(800) 853-2651
SHOP NOW

Recent content by molinegb

Yesterday's Tractor Forums
  1. M

    Swap a 504 from an MM705 into a white 1870 / G955?

    5 digit heads. rather than 4222's. Believe injectors different and square port heads. Send me a message and can maybe set up with parts needed.
  2. M

    Swap a 504 from an MM705 into a white 1870 / G955?

    Seal won't go over flange. Might bolt on but think piston are aluminum and not flat top. Would never run right.. Later 451 is a one of its own. Think rods and pistons different as well as heads. May as well change whole motor, flywheel and front pulley.
  3. M

    Swap a 504 from an MM705 into a white 1870 / G955?

    Don't believe many parts would work besides a complete swap. Thousands of g705's 400 some 1870's. Injection different and crank.
  4. M

    G 1000 maybe sell

    Had on just like it. Sold for 1500$ Ring and pinion was bad.
  5. M

    Allis D Grader Pulley

    Helping friend install motor in grader. About a 1953. Original motor has a three pulley setup with a hand crank claw on fron with three bolts and claw appears to be threaded on. Motor just installed had a single pulley with a bolt in side to lock in. Suspect original has a keyed crank? Did...
  6. M

    Wanted Stanley Mn to Nd

    Smaller tractor parts. Fit in 1/2 ton truck. Stanley MN to Wolford ,.Bottineau or Westhope
  7. M

    U hydraulic

    You need a hydraulic lock so cylinders can be disconnected. MM cylinder has it's own lock. Should be lots of used. Almost all U/G here had one.
  8. M

    Minneapolis Moline U Transmission and Differential seals

    1954 is a hard to find year of UTS. Very low production.
  9. M

    Marvel Schebler Carb question

    Won't change anything. I always make my own gaskets.
  10. M

    Oliver 70 Rear Seal Replacement

    Been trying to change rear seal. New rope is about 3 x as big as original cork one. Top seal retainer will only roll 1/4 way back into position. Have crank mains backed off but crank not droppping enough to make more room. Motor is in chassis. Anyone done one with the Felpro seal?
  11. M

    Another Z question

    What year? Shroud is off a 38-39. I can measure some of mine if know year. Was a rad changeup in 1940. Maybe a R radiator. All have same JT part # but with different suffix.
  12. M

    ZTU radiator question

    Was like 4 versions. Same dimensions but inlet and outlets were offset or in different positions. U was the same. All should work with modifications. Pretty sure R will work also. Should be a tag on radiator from company that made it.
  13. M

    Ih 3414 Steering.

    Looking at a 3414 same as 414. It is an early one with single pump for power steering. Steering quit and valve was removed and lost. Manual shows 3 valves 379205r92 381352r92 and 379645r92. N|eed to find which valve needed or can be update with valve off another model. Has no serial # so...
  14. M

    G704 engine parts

    My G704 was 4 3/4 but went back to 4 1/4 as wanted original.
  15. M

    G704 engine parts

    Have few sets in stock.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top