-
M
Bad head or gasket?
On my UB there is leakage inbetween the head and the head gasket. At first start up it doesn't leak while running until it is put under a load. When it comes off of load it stops oozing out. I have retorqued to M5 specs and still no luck . It has 4207 heads and M5 blocks standard bore.- Molineub55
- Thread
- Replies: 2
- Forum: Minneapolis-Moline
-
M
Case rod
What is the length center to center? On what stroke were you using these rods?- Molineub55
- Post #1
- Forum: Minneapolis-Moline
-
M
Compression height of pistons/ deck clearance
What's the compression height of a 283 standard pistons and the clearance from top of piston to top of deck? Thanks!- Molineub55
- Thread
- Replies: 1
- Forum: Minneapolis-Moline
-
M
Weight of UB
How much does the big cast rear hubs/centers weigh? Is it easy to get a UB to weigh #5000 that has a wide front? What is the lightest UB puller known?- Molineub55
- Thread
- Replies: 5
- Forum: Minneapolis-Moline
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy