(800) 853-2651
SHOP NOW

Recent content by Moonlite37

Yesterday's Tractor Forums
  1. M

    McCormick 25V sickle mower parts

    That part is the same for all tractor mowers of that era.. You may find used one if new is not available
  2. M

    IH 574 Gas - Popping Under Load - At my wit's end

    A Compression chamber leakdown will tell you a lot more tha a compression test
  3. M

    install new bottom seal on overhead door

    There are several kinds of seals. The name of the manufacturer is of little help. Just cut off a small piece of the seal and take with you to the door shop.
  4. M

    Storm windows - who makes them?

    QUAKER Maufacturing Co. Freeburg, Missouri. About 25 miles south of Jefferson City
  5. M

    mowing wet weeds in California

    Four wheel drive helps as the front axle and rear axle is hooked together and the brakes on rear axle helps to control with brakes
  6. M

    How old of a bull can be fixed

    When I was teaching, there was a senior boy who worked part time for a cattle framer and he would castrate and dehorn large bulls that the owner of the farm bought at the sale barn, These animals may weigh 1500 +- . This boy was tough and now run a national-w`ide truck salvage1 yard. He was...
  7. M

    Plow Days in Missouri - 2024?

    Welcome. I have been to Irondale to see the grave of the Irondale is the home of Wiliam Moses Helms and also near where Sam Helderbrand was from.
  8. M

    electric tee post pounder

    My renter's FIL has a gas powered one that my renter uses. I do not know anything about it except saw that it was in use on my farm when he only had abut six to drive, I am sure it is heavy but my renter is a giant
  9. M

    Gilson tractor

    Sorry, I did not read carefully. Spelling is different.
  10. M

    Gilson tractor

    I HAV1E SEEN A FEW WITHOUT A STEERING WHEEL, JUST A LEVER FOR STEERING sorry for caps
  11. M

    Chicken or the egg. Machine tools

    An old metalworking textbook explains that early lathes were called lathes because a lath is the name for a thin narrow board which was bent down and in springing back as it unwound turned the piece. I think that the early wood lathes were powered by an Egyptian slave running pulling a rope and...
  12. M

    small progress on big swamp buggy

    Get a new nut and see if it will work, maybe use a thread file.
  13. M

    How long can alfalfa seeds be stored?

    I do not think a 300% overseed will hurt. I limited mine to 10 pounds because I am stingy and had rather have 12 to 15
  14. M

    Braze it or weld it?

    I would braze it and be done with it before you could go look for a new one. Then check for warpage and grind it til all gasket surfaces match.
  15. M

    580 case wheel bolt repair

    That is the way I did my IHC 574. Almost no actual cost
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top