(800) 853-2651
SHOP NOW

Recent content by Morries roessler

Yesterday's Tractor Forums
  1. M

    JD 314

    Thanks Bob, Jim, and Roger for your input. It was very helpful. Forgot to say that the deck wont go up or down either, but that stands to reason if the pump is not turning. With deck in the up position it might fun trying to get it off. As far as serial# goes, it sets in the shed a my nephews in...
  2. M

    JD 314

    T0 All that answered my question...Bob asked if I knew what was wrong with it.. Bob, the drive shaft from engine to trans turns the input shaft on trans but does not move the tractor and the cooler fan on trans barley moves or moves very slowly... Hope this helps. I should have said that the...
  3. M

    JD 314

    Hi Guys, I was wondering if anybody could tell me if a hydrostatic transmission from a 140 JD lawnmower would fit into a 314 JD mower. I have a 314 with bad trans and neighbor has a shot 140 with good trans. Will they interchange?
  4. M

    B leaking gas from pulley.

    You have a crank case full if gas.DO NOT RUN THIS ENGINE. Drain the oil, let it drip out over night and replace oil and filter. The situation you have happens when the gas shutoff is left on when not using the tractor. The gas runs past needle and seat, into the cylinders and then into the...
  5. M

    John Deere Question

    I have a 1945 B with a dip stick where the oil petcock goes,I know it is a aftermarket thing but seems to work alright. As for spinout rims, never seen such an animal on a JD.
  6. M

    John Deere Batteries

    My experience from anything made by Exide was crap. Two pickups and a car. In a six mounth period they go to heck. Then if you charged then , wouldn't take a charge and maybe start the vehicle about once. Take them back to our local hardware dealer where they were bought and he always want to...
  7. M

    aircraft generator

    Thanks Jerry, and yes I believe it was from an old 2 row Moline combine. Yellow and hand crank it. Hated the fact that they would start right up in a couple cranks cold. We would blow the chaft and dust off as much as we could and fuel them hot while running or otherwise u could crank until you...
  8. M

    aircraft generator

    Thanks again for posting drawing. Now I can actually start scrounging around for parts . Thanks Bob.
  9. M

    aircraft generator

    Thank for the link Bob. Much appreciated. Couldn't get it to come up right now, but will try again later.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top