(800) 853-2651
SHOP NOW

Recent content by Mpat70

Yesterday's Tractor Forums
  1. M

    Allis Chalmers D14 power steering

    Thanks for the info
  2. M

    Allis Chalmers D14 power steering

    Thanks for the info
  3. M

    Allis Chalmers D14 power steering

    Hello all, I have a D14 Industrial. It's a rare piece of equipment with the Loader Backhoe factory installed. It has the shuttle shift on the left side. It's my understanding that only about 1500 were ever made. My power steering is leaking at the shaft. It's wobbly so I think I will need a...
  4. M

    No reverse power on D14

    Thank you for your help. I was able to find some frome a local guy that parted one out. Hope to get it running this weekend.
  5. M

    No reverse power on D14

    I took the side cover off and whom ever attempted to adjust the shuttle clutch shims were not very knowledgeable on what they were doing. Some of the 0.015" center shims were moved to the forward outside edge which caused damage to the shim due to the shim being too long for the outer edges...
  6. M

    No reverse power on D14

    Yes sir. The shuttle is on the left and it's forward or reverse with a nuturel notch in the middle. This is equipped with an oil cooler so I will have to remove the lines before I can remove the cover. I have a shop manual so now that I know what's recommend I can refer to the book for...
  7. M

    No reverse power on D14

    Can anyone please help. If I'm on level ground then my D14 industrial goes forward and reverse fairly well. But if I'm on an incline then I cannot back up hill. I'm not talking steep either. I have changed the transmission, shuttle clutch and differential fluids and went with universal hydraulic...
  8. M

    Power steering D14, D15

    Hey guys I need some advice. Finally got the old girl running and using her is fun except one thing. When I have a load in the loader the steering is really hard to turn. Without load it turns easy and great. Any suggestions would be appreciated. Full on oil but does leak.
  9. M

    Fuel tank?

    Ok. Thanks guys
  10. M

    Fuel tank?

    Will a gas tank off of either a WD or WD45 fit a D14?
  11. M

    Fuel tank liner?

    Anyone have any experience with the fuel tank liners? I havery a gas tank that is rusted and am considering the liner kit.
  12. M

    Can anyone tell me what is a belt pulley

    What is a belt pulley and how is it used
  13. M

    Timing

    OK so I set my points at .025 gap. Set the tapping .0808 intake and .014 exhaust. With #1 and #4 at TDC respectively. Bought a timing light and followed your instructions carefully and now she is purring like a kitten.Thank You!!
  14. M

    Timing

    Sorry but what an advance?
  15. M

    Timing

    I call backlash where you have it running pretty good but every so often it hiccups
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top