(800) 853-2651
SHOP NOW

Recent content by mrhud

Yesterday's Tractor Forums
  1. M

    john deere b crankshafts

    the one i have is a 1940 the doner parts are1948 so the doner will go to scrape and i wil have to look for a crank
  2. M

    john deere b crankshafts

    dont know that it is all buttoned up and out back in the bone yard iwill guess by the sn crank would be ab592r nicetractor all new rubber on spokes good origanal paint no dents the owner died about five years ago
  3. M

    john deere b crankshafts

    its about .040 oval shaped on the rod jounals it was ran with a broken oil line going to the govenor and ruined it thats re done now the crank needs done to finish it
  4. M

    john deere b crankshafts

    rods are poured babbit but they can easily be machined to fit a snap in bearing shell
  5. M

    john deere b crankshafts

    just want it done and gone not biulding a puller
  6. M

    john deere b crankshafts

    i have a b82051 that has a crank that is realy bad would have to be welded i have a b 212731 that is going to scrap unless i can use the rods and crank in the hand start early b any know the differances. thanks Hudco
  7. M

    will a early ford narrow front 4000 fit on a 6000

    knew they wouldnt interchange but how many of the inturnales are the same discs shafts regulatoers and things
  8. M

    will a early ford narrow front 4000 fit on a 6000

    while i have every one going here how much differance i s there in the two selecto speeds early 4000 and the 6000
  9. M

    will a early ford narrow front 4000 fit on a 6000

    thanks thats what i was hoping
  10. M

    will a early ford narrow front 4000 fit on a 6000

    will it bolt up to the 6000 boltser the tie rods bolt to. thanks Hud
  11. M

    will a early ford narrow front 4000 fit on a 6000

    willthe front ends interchange could i take the narrow front end of a early 4000 the hundred series looking sheetmetal an d put that front end axle on a 6000
    • mrhud
    • Thread
    • Replies: 12
    • Forum: Ford
  12. M

    d17 6cyl gas or wd45 6 cyl gas

    does any of the antquie tractor puller clubs allow the d17 262 diesel or the wd45 230 desiel repowered with the 262 gas or 230 gas withou just being in a exibition class
  13. M

    any one use these small gps speedometers

    any one use the small gps speedmeters made for bicyles or cars looks like you can get about any of them for about 50.00
  14. M

    LB/SB Topcut Tires

    is their any advantage to having radials because most places dont allow them
  15. M

    LB/SB Topcut Tires

    the bars are pretty tall but thier is zero give in the side walls i am afraid if i run any lower air i would spin the tube valve stem
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top