-
M
2n wiring trouble
Here is a copy of the wiring diagram that I used. Thanks. Here is the link to the diagram. Untitled URL Link- mrice2311
- Post #1
- Forum: Ford 9N, 2N & 8N
-
M
2n wiring trouble
I just converted my Ford 2N to 12 Volt using the Tisco 12V Conversion kit. I removed all old wiring and started new, following the diagram. Tractor started right up, runs good. Problem: My ammeter shows -30 when running, why? Also, I connected my lights to the bottom post of the resistor assy...- mrice2311
- Thread
- Replies: 5
- Forum: Ford 9N, 2N & 8N
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy