Recent content by mt matt

  1. M

    perkins water pump

    has any body seen one of these power units?
  2. M

    perkins water pump

    so, I have a Massey stationary power unit that seems to have a water pump on the engine that does not exist in the parts books. casting # 37712541 same as 1100 1130 tractors but with a keyed and threaded shaft instead of a press on pulley. I spent 2 hrs. at the Massey dealer looking at parts...
  3. M

    4010 jd valves sticking

    Could be I think it probably still had the breakin oil in it when I got it but I don't know for sure. so I have been trying to use it as a tractor not jusr puttin around.
  4. M

    4010 jd valves sticking

    Wiil check in to it
  5. M

    4010 jd valves sticking

    I find that hard to believe too, but that is what happened twice!
  6. M

    4010 jd valves sticking

    Ok I will do some more looking I blieve all that is right so maybe I will need to takeapart and clean will check for valve movement.
  7. M

    4010 jd valves sticking

    there is oil dripping off the rocker arms but not enough to spash all over.
  8. M

    4010 jd valves sticking

    will they wiggle with the sprigs in place ? are there different size valve guids available or are they all standard?
  9. M

    4010 jd valves sticking

    it is diesel I am getting some oil I just don't know if it is enough, how do i tell that?
  10. M

    4010 jd valves sticking

    it was overhauled about 6 years ago ran till the loader broke then sat about 4 years I bought it last year when I went to pick it up we put bateries in and it started right up. we loaded it and let it run for an hour then shut off to haul home 2 hrs. next morning I started it and it bent 4 push...
  11. M

    4010 jd valves sticking

    I have a4010 jd that has beenrecentlyoverhauled and thensat for several years. I seems as though maybe it is not getting enough oil to the valves, theysomtimes stick and then predictably it bend push rods,I have good oil pressure (30) lbs . Any thoughts?
  12. M

    case 930 over fueling on one cylinder

    should not pull too hard has the 401 engine what is 336bdt? but yeah I will check out temps.
  13. M

    case 930 over fueling on one cylinder

    thanks for the help I am planning to use for runing an irrigation pump.
  14. M

    case 930 over fueling on one cylinder

    So if I have all the sleeves lined up and the engine sounds good on a tractor I got for free cause the engine was stuck and I got it going is that close enough?
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top