Recent content by n9viw

  1. N

    #2 Allis Chalmers Plow Manual

    F150, do you have a set of coulters for an AC #2? I just used this post (among others, like Bevan's other one) to identify the tractor I received from my father as an AC #2, but it's missing the coulters from blocks to discs, and the drawbar/hitch setup. Got any of that? TIA, Nick
  2. N

    Points ignition causing alternator damage?

    Long-term review: The alternator with new innards is still charging just fine. I still have not replaced the ammeter, but the charge rate has caught up to the battery life, so it rarely rises over 10A. The old coil and resistor are doing well with the new wires, and since I re-timed the...
  3. N

    Points ignition causing alternator damage?

    So, I replaced the copper wires with the spiral-wound wires last week, and also replaced the condenser and points in the distributor. I re-timed the distributor to #1 TDC, or just slightly after (as per the owner's man), and got the old girl fired off. I had to play around with the carb mix, as...
  4. N

    How to combat rust in alternator?

    Will do, thanks Allan! Nick
  5. N

    How to combat rust in alternator?

    The patient: A NON-SHEDDED '49 Farmall M with Delco 10si 3-wire alt, neg. ground 12v conversion. No shed because I haven't got one... yet. I've got the alternator apart to replace the internal regulator, which went belly-up due to the PO's bad wiring. There's a lot of rust in there...
  6. N

    Points ignition causing alternator damage?

    @Owen: No, this was not a one-wire, I said it ACTED like one. As I said previously, it's your usual Delco 10si, THREE WIRE alternator. I was not, however, aware that the alternator should not put out power in the absence of voltage on the sense lead... further proof that the first alternator in...
  7. N

    Points ignition causing alternator damage?

    @JohnM: No, it's your usual 10si with the internal regulator, but as for the two terminals on the regulator (voltage Sense (#2 terminal) and Excite (#1)), NEITHER was connected. In the absence of any voltage to the Excite terminal, it was behaving like a one-wire, and requiring high RPMs to...
  8. N

    Points ignition causing alternator damage?

    Hey all, I have a '49 Farmall M that came to me converted to 12v (stock 6v starter and pushbutton start switch, Delco 10si alternator, IH ignition with can-style coil and resistor, copper wires). I keep burning out alternators, and I wonder if the points ignition (or the RF coming from it)...
  9. N

    Farmall M Hydraulics- pics please?

    Mkirsch, Thanks for the input. I've learned quite a bit over the last few days, thanks to all of you who've replied here! I like the idea of the bungee cord versus the hose clamp, but as power down is about the same as gravity down, I don't think I'll be too concerned. If it must be held...
  10. N

    Farmall M Hydraulics- pics please?

    Jim, I took the M out mowing, and discovered that the remote control valve is indeed double-action- the upper of the two rear ports provides pressure when the rod is pulled toward the driver, the lower of the rear ports provides pressure when the rod is pushed in. During this, the main rod...
  11. N

    Farmall M Hydraulics- pics please?

    Jim, I think this is the "christmas tree" type valve, as you can (maybe) tell from the pictures. It does not bolt on to a separate bracket, but instead threads into a pipe, which then threads to an elbow that tees into the filler neck. There are indeed four ports, the one in the front...
  12. N

    Farmall M Hydraulics- pics please?

    Jim, Thanks again for all your help, I really appreciate it. I just want to make sure I'm using this thing in the right manner- not that it seems to be doing any damage to run it the way I am, but just so it's correct. My current setup is as follows: * Single line from Lift-All output on...
  13. N

    Farmall M Hydraulics- pics please?

    CaterpillarGuy: So, are you saying that the factory Remote Control valve is double-action? I don't know that I would have figured that out, as I've been pushing both rods forward to lower the 3-point hitch, which would have cut power to the Remote valve before it had a chance to engage its down...
  14. N

    Farmall M Hydraulics- pics please?

    Jim, Thanks for the diagram, that helps. I do like your setup - that would, indeed, give a true double action circuit, which would help if I had (as I would like to in the future) a front end loader. My system is good enough as power up and gravity down, for now. Your explanation about...
  15. N

    How Far Have any Body went Running on a Flat Tire

    My wife and I borrowed a friend's 25' tandem-axle horse trailer to move from IL to MO. We swapped out one tire (down to the belts) for the not-much-better spare only 50 miles out... we drove the rest of the way hell bent for leather, as we had no other spares. We pulled in 12 hours and 400 miles...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top