(800) 853-2651
SHOP NOW

Recent content by neil33

Yesterday's Tractor Forums
  1. N

    Cracked block?...advice please

    Thanks for the input and advice guys, further research from others that know this particular engine (BD144) well seem to think that most engines will look like this because of the very thin walls between the chambers and that it will cause little problem as long as the head is straight and the...
  2. N

    Cracked block?...advice please

    So I decided to do a full rebuild of my B275 engine and after pulling the first 2 cylinder sleeves l have found hairline cracks at the thinnest point between cylinders 1-2, 2-3 and 3-4 (see photos). I have little experience with these engines and rebuilding in general so I'm looking for advice...
  3. N

    BD144. Main bearing change w/out Crank removal?

    Thanks guys, much appreciated. Is it just as easy to push the new upper bearing into place using the same cotter pin method?
  4. N

    BD144. Main bearing change w/out Crank removal?

    So I have a question for you guys...... Is it possible to change the main bearing shells without removing the crank from the engine? My thinking is that if I remove all bearing caps I might be able to drop the crank enough to push the upper shells out and push the new ones in. My...
  5. N

    B275 poor compression/ Pre combustion Chambers

    Thanks JDEM...... The chambers did indeed have both upper and lower copper seals in place (as well as the mysterious sealant) my only thought was that maybe the seat of the lower seals might be corroded and the seal washers not sealing well....hence someone using an additional sealant around the...
  6. N

    B275 poor compression/ Pre combustion Chambers

    Hello All, I'm kind of new to the vintage tractor thing and have just take over a part restored B275 that had already had some work to the cylinder head (skimmed and valves re ground) but on turning the engine over by hand it seemed to be loosing compression past 2 of the pre combustion...
  7. N

    B275-Which fuel filter?

    Thanks so much guys..it all makes sense now. I'm still pretty new to the vintage tractor thing and still trying to find the best sources for information and the CaseIH.com site will prove very useful during the restoration.
  8. N

    B275-Which fuel filter?

    Current filter is a FRAM C1191PL
  9. N

    B275-Which fuel filter?

    Here you go....
  10. N

    B275-Which fuel filter?

    Hello All!...just purchased a B275 as my first tractor and first job was to clean out the fuel system and change fuel filter however, when searching for the filter it appears there are several listed for the B275 including a metal canister type and a paper type. Tractor is an early 1960 model...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top