(800) 853-2651
SHOP NOW

Recent content by Nelson1962

Yesterday's Tractor Forums
  1. N

    bush hog ....ford 800

    Thanks to everybody for the infomation. I have a 5 speed model 800 tractor.
  2. N

    bush hog ....ford 800

    I have a ford 800 try to hook a king kutter tiller together . The pto shaft from the cutter is 4 to 6 inch too long. I Have the saft pushed all the way together. There's no adjustments . Did the ford 800 come with 2 different lenths 3 point hitch bars ?
  3. N

    ford 800

    Thanks for the infomation.. The tractor has a new distruber with new points and condencer, New coil and all new electrical wiring. Does anyone have any paper work on how to tune this carb. in to the propure settings ??
  4. N

    ford 800

    You said clean and rebild the old carb.. Why ? Is the new Carb junk ?
  5. N

    ford 800

    No rust or trash .. The take has been clean and new gas.. How can I adjust this new carb. Could the setting be off from the factory.. How many screw turn out should the carb. be set at...? Thanks for your help.. Nelson
  6. N

    ford 800

    Hey I"ve check the spark and plenty of wire there . Soon as the engine shut off I can restart it by pulling the choke and it will run for 2 or 3 mins and then it shuts down again. There"s no inline filter and I replaced the fuel filter shut off in the tank.. The only thing left is the fuel bowl...
  7. N

    ford 800

    I have a ford 800 that will not stay running. I replaced the carb. with a new zenith carb. It will run for a little bit then cuts off like its starving for gas. I tried ajusting the only screw on the carb. But it doesn't make a difference. I replaced the fuel filter in the tank and that...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top