-
N
Warm hard start
Sounds like cables on this end. My 1086 acted the same way. Cables looked good but everything else checked out so replaced cables and ended the hard start problem.- Nelson43
- Post #1
- Forum: John Deere
-
N
Fuel calibration???
I pulled the 362 LPG engine out of a 4020 and put a 340 gasoline engine from an old 105 combine in it. Using the intake manifold for the 4020 I hooked everything up and cannot get the engine to run smoothly on LP. A mechanic told me that the carburation for the LP system is set to run on the 362...- Nelson43
- Thread
- Replies: 2
- Forum: John Deere
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy