(800) 853-2651
SHOP NOW

Recent content by nhoefler

Yesterday's Tractor Forums
  1. N

    Farmall H Starting/Stalling

    Long overdue update here. I ended up following pretty much any and all advice here, bought a rebuild kit and tore the carb down to every last piece and went through every single passageway. No obstructions but the float was definitely off from the specs provided for its stops so adjusted that...
  2. N

    Farmall H Starting/Stalling

    I indicated that I used TDC and those details to ensure I had the correct wire for #1 cylinder off the distributor, to basically start from scratch and not assume anything was correct, I did not give any details on the second portion where I actually set timing (my bad). I used the first of the...
  3. N

    Farmall H Starting/Stalling

    Hello everyone, open to any helpful suggestions or thoughts on getting this old girl back running properly. Long story short, it has been sitting a few years (inside) not run much and now at the point of it will start (with some struggle) and sounds really good, but will stall out in a matter of...
  4. N

    Farmall B Pneumatic Lift-All or Exhaust Lift

    Thanks Guys. I guess I should have added/clarified a bit too, I think functionally I have all the components and it is in working order, just needing the seals or whatever would be involved from that side which unfortunately I'm sure all the used parts would have the same issue. Might have to...
  5. N

    Farmall B Pneumatic Lift-All or Exhaust Lift

    Hello Everyone, Wondering if there is anyone still around that has any experience with these old exhaust lifts? Plenty of old old posts on it but the main question was if anyone knew of a place to source parts for it before I tear into ours? Farmall B with a cultivator, when I pull the lever...
  6. N

    IH 1086 Coolant Temp

    This is a 78 as well. Looking into it more the oil pressure gauge has about the same symptoms (reading, but low) so I hear you on the concern/worry part.
  7. N

    IH 1086 Coolant Temp

    Temp gun was my next thought I guess that's where I'm not sure what I'm looking for. For example what gauge positions correspond to what temp in Fahrenheit? Really just trying to find info to fact check the gauge to see if there really is a problem but not finding much for a reference.
  8. N

    IH 1086 Coolant Temp

    Hello guys just curious if anyone has ran across this before. Obviously I know there are a few different causes of a cooling gauge not working but this one is a little different. It seems to work and very up and down with engine warm verse cold like it should but for some reason just seems to...
  9. N

    F-20 Governor Linkage Cover?

    I'm actually over on the NE side of Iowa. Yes please let me know if you do!
  10. N

    F-20 Governor Linkage Cover?

    Hello Guys, Hoping someone can help identify either a part # or even better a source for the cover shown in my picture that I am missing as part of my 1935 F-20 restoration. It is a two-bolt cover that is on the linkage from the governor to carburetor at the 90 degree joint it makes on the...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top