Recent content by nickscuda

  1. N

    Oliver 1365 rear end oil leak.

    Thanks very much for the reply Mitch. I was hoping I could do the seals without taking the complete rear housing off and taking the carrier out and stuff. As my project comes along I to am becoming a bit of a fiat guru, lol. This tractor of mine was also kind of neglected in its previous life...
  2. N

    Oliver 1365 rear end oil leak.

    So, I got thinking, I filled the rear end/hydraulics/ transmission through the hole right beside/under the seat. Did I over fill the rear end? thinking about the proper oil level in relation to the axle seals. because this wasn't leaking before I topped the oil up, before I toped it up the...
  3. N

    Oliver 1365 rear end oil leak.

    Ya, so went to the garage tonight ( to re-seal the top cover of the injector pump) and found a puddle of oil under the other side coming out of the same cotter pin hole. I think my big fear is that when I get in there I'll find the carrier side bearings gone causing the whole problem. Pretty...
  4. N

    1365 hydraulic pump kit

    Have you got your old pump apart yet? in my experience those aluminum body pumps usually aren't worth re-sealing. You hay very well find that the housing is scored once apart (where the gears turn). New pump from a hydraulic shop run from $250 - $400 or so depending on where you live. May...
  5. N

    Oliver 1365 rear end oil leak.

    Been working on this tractor for a couple months now. I had never had the rear end oil at the proper level yet. I replaced a leaking transfer case output seal, then filled the rear end to the proper level. Now wouldn't you know it, I have another leak, this time coming out of the brake drum...
  6. N

    White 2-60 transmisson/ rear end oil???

    I'm sure this is a topic that has been beaten to death. Manual says 20w40 ( I think ) engine oil for transmission/ rear end/ hydraulics. I'm tempted to go with a TDH type fluid. Thoughts on this. Also Rear end final drives call for the same 20w40 oil, thinking I'm gonna go 80w90 gear oil...
  7. N

    white 2-60/ oliver 1365

    Thanks for the offer. I'm in Ontario Canada and have import tractor parts only a little over an hour away from me. I've gotten parts from him before, seems OK to deal with. But even though he is so close he'll only deal online and in American money which sucks a bit for us Canadians right now.
  8. N

    white 2-60/ oliver 1365

    I actually haven't checked the pre-heater yet (only had the tractor for a couple weeks so far), it's been in my warm garage so didn't feel there should be a need for it in there. Also About the towing it to start, I had heard that before about these tractors and worked on one a couple years ago...
  9. N

    white 2-60/ oliver 1365

    Starter and battery are brand new and seems to spin over at a normal rate.
  10. N

    white 2-60/ oliver 1365

    Thanks for the reply, nice tractor you have there. I'm hoping once I get the fuel filters changed (that have obvious water in the separator bowl) and fix the return line that the starting gets better. May run it on concentrate Liqui moly as well give the injectors the best chance I can.
  11. N

    white 2-60/ oliver 1365

    Ya I know its a lot of hours but they do seem to last pretty well. The tractor does have the 1365/1370 style grill on it too.
  12. N

    white 2-60/ oliver 1365

    HI! new to the forum here, seen this site many times and finally became a member. Couple of questions for those in the know. I have just purchased a white 2-60 FWA with loader. Now the paint is peeling off the chassis in places and green Oliver paint is underneath. The dash serial number...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top