(800) 853-2651
SHOP NOW

Recent content by NolanJae

Yesterday's Tractor Forums
  1. N

    Case 40 XT Skid Steer---Synthetic or Dino Oil???

    I just bought a 2003 case 40xt and wanted to do my own service to know its done right. This loader is for on the farm work- ie small beef farm/snow removal/ minor dirt work/ cut wood and the like. I live south of Duluth Mn by an hour and have seen 30 below many times. Wish I could afford...
  2. N

    M lift-all reservior----motor oil or Hy-tran??

    it does have a filter- in-line but i also have a couple other tractors and will swap tractors if needed. I'll run hy trans. it smells like hytrans anyways thanks
  3. N

    M lift-all reservior----motor oil or Hy-tran??

    I need to add oil to my lift all reservoir. I'm not sure what type of oil is in it sooo I will drain and replace. I've looked back in previous posts and found varrying views. The manual says replace with motor oil- but I have seen posts where guys are replacing with Hy-tran. Also the...
  4. N

    M hydraulic problems could use some experience here

    I have learned a lot. I assumed instead of read the manual. I did remove the dipstick and it is low in the reservoir. Thanks for all the advise. I'm sure things are going to work fine once I add poper amount of fluid. The hose--which you asked where it went in at goes in from the...
  5. N

    M hydraulic problems could use some experience here

    got some things to try thanks---call me ignorant but i was under the understanding that the reservior came out of the trans area and vise versa? Is the oil shared gears/hydro or does it have a seperate reservior? The line your asking about goes into the side of the clutch housing.
  6. N

    M hydraulic problems could use some experience here

    so would you try and bypass that filter to see if that is the cause or different filter or should that have been placed on the other hydro line?
  7. N

    M hydraulic problems could use some experience here

    looking fro some info on what type of Hydraulics I have on my M and what could be wrong with them. I am going to attach some photographs This is my wifes late grandfathers M tractor. I picked it up a couple years ago and have been working on it to get it up to par. Runs like a champ but I...
  8. N

    what type of haybine should I look for??

    thanks Ill keep an eye out for a 290
  9. N

    what type of haybine should I look for??

    How many pennies should a guy save? I'm hoping to get one in good shape for at or under 2,000. Am I dreaming???
  10. N

    what type of haybine should I look for??

    I have New holland, IH, John Deere and one good all around implement dealer withing 30 miles.
  11. N

    what type of haybine should I look for??

    I live in north central Minnesota and I have a hobby farm. I have 30 acres of hay ground and cut grass hay two times a year. Were lucky to get two cuts. I just scrapped out an Owatonna haymaster 200 for many reason and I'm on the hunt for a haybine. I want to find a haybine that will cut a...
  12. N

    460 Exhaust Manifold Pipe

    ITS THE RIGHT PART --AS OTHERS INDICATED BUT THEY ALSO FIT THE 460-06 MODELS- EVEN WITH THE OFF SET IT STILL REQUIRES SOME TIN WORK. I PUT ONE ON AND IT HAD A HOLE IN THE CASTING--SENT BACK FOR ANOTHER ONE. AS SOMEONE MENTIONED YOU NEED TO WORK ON THE CASTING TO GET THE HEAT RISER TO WORK...
  13. N

    Hot Coil?? is it bad.

    I tried all those things- 3rd set of plugs- new points/ condensor times. Air leak would make it those cylinders run lean- dont know what else to do. Valves are timed and compression is great- good oil pressure leaves 2 things spark and fuel. Been through he carb atleast 4 times now...
  14. N

    Hot Coil?? is it bad.

    Thanks for the info. I dont know much about electrical systems. I'm still leaning towards a carb issue but would a coil cause a rich running motor due to lack or low spark? I've gone through the carb several times- soak-blow-clean-adjust float each time and now im haveing to lean the main...
  15. N

    Hot Coil?? is it bad.

    I pulled the valve cover and adjusted the valves on on my 460, pulled the plugs, checked the points. My 460 has been acting up- rich under power/idle ect. Last couple times ive tried to start her it acts likes its flooded but will start. After the valves and points I left the key on and took...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top