(800) 853-2651
SHOP NOW

Recent content by normg7

Yesterday's Tractor Forums
  1. N

    JD 110 Flat fender

    Here are some pictures
  2. N

    JD 110 Flat fender

    There is power when ignition is on at the condenser, not cranking
  3. N

    JD 110 Flat fender

    As far as I can tell its all original. There are 2 wires coming from the magneto. They attach to the condenser then the points. I have power at the terminal where they attach to the condenser but no spark. Everything else electrical works. But the PTO switch Is backwards, It wont turn over...
  4. N

    JD 110 Flat fender

    It has a magneto ignition system. Is there a way to check the magneto?
  5. N

    JD 110 Flat fender

    I have a 110 flat fender serial number 133xxx. I have no spark, power to the points but no spark. Any suggestions on where to go next?
  6. T

    Mini Excavators

    This message is a reply to an archived post by Formerly PaMike on January 12, 2014 at 04:27:15. The original subject was "Re: Mini Excavators". Hey guys im new here but i just purchased a kubota 61-2 mini ex and was just wondering if it is a eropean model. I was told it was and if so whats the...
  7. B

    generator runs after polarizing

    I have a 45 farmall A with a positive ground system after I polarize the generator it spins like an electric motor! the battery starts to drain and terminals get hot. what can it be?? thanks!!
  8. N

    replacing wiring for 1952 Harry Ferguson TO30

    try ebay, i needed a harness for a tractor and found one there. at least they should have schematics for you
  9. N

    51 MT temperature seems hot

    a 51 mt was the first tractor i got to drive when i was a kid. my grandfathers dad bought it new. it always ran 200 or better no load and about 230 working. grandpa said it did it since new and had no ill effects for 30 or so years. wish my dad wouldnt have sold it
  10. N

    mower deck replacement

    the decks are essentially the same but the mountings are alot different. you could change the mounts, a little welding and fabricating but not horrible
  11. N

    What sandblaster equipment do I need?

    pressure blasters work the best but are very needy when it comes to air volume. i have a small one, holds about 40 lbs of sand, 5 horse 2 stage compressor 60 gallon tank works but once in awhile i have to stop for the compressor to catch up
  12. N

    2010 industrial

    to be fair to the 2010. i have a 2010u that has been a good tractor for me. loader has never let me down and after figuring out the electrical system, it had no lights, its been troublefree. yes parts are expensive but what JD parts arent. just be very careful and check out the tractor...
  13. N

    318 turns over but does not start

    i had one with a B43 engine the condenser went bad
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top