Recent content by NRG

  1. N

    Char-Lynn Power Steering

    The first one I put new seals in did the same thing. I found this illustration from a Char-Lynn manual. The ends of the slot in the drive need to line up with the low valley spots in the star gear.
  2. N

    Farmall M with Fast Hitch

    I got the tractor from a local consignment auction. I talked to the auctioneer and found out who's tractor it was. It happened to be a local farmer not far from me. I was told he liked to add custom things to his tractor. The steering is fully hydraulic. He made the front bolster to mount a...
  3. N

    Farmall M with Fast Hitch

    I was wondering if anybody recognized the brand of this hitch. It's build fairly heavy with a lot of adjustments to change the angle and pitch of the implement. There is a very stiff spring built into the front mount. The receiver tubes pivot out so that if you had 3 point adapters you could...
  4. N

    Farmall M with MW Fast Hitch

    <image src="http://forums.yesterdaystractors.com/photos/mvphoto21474.jpg"/> <image src="http://forums.yesterdaystractors.com/photos/mvphoto21475.jpg"/> <image src="http://forums.yesterdaystractors.com/photos/mvphoto21476.jpg"/> <image...
  5. N

    Farmall 300 FH TA delete

    I bought one two years ago with TA delete, standard drawbar, and transmission driven pto, but it did have fenders.
  6. N

    farmall H bull pinion bearing cage o-ring

    I use part # 568-357 at my local hydraulic shop. Usually cost me about $5 pair. They are O-rings and not the square ones but I have good luck with them.
  7. N

    660 LP dash question

    It's a metal blank cover with a clip on back to hold it in place. I'll try to get a picture of mine.
  8. N

    Odd Farmall H hydraulic pump shaft

    I wondered if anybody knows what this is. there wasn't any parts to connect it to the countershaft drive.
  9. N

    Anyone on here run a single wheel front end?

    I have been running this for a few years. I'm looking for another one to fit on my H.
  10. N

    farmall H bull pinion bearing cage o-ring

    I had my local hydraulic shop size me up an o-ring. Their part # is 568-357 They cost me about $2 apiece. Hope this helps.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top