Recent content by Old Eb

  1. O

    DC value?

    EC Indiana. You should assume it has no tires on it.
  2. O

    DC value?

    Wasn't interested enough at the time to get the serial number I guess, but now wish I had. Hand clutch. Essentially no tires on it as they are flat, rotted and junk.
  3. O

    DC value?

    Ran across a Power Lift DC that has obviously been stored inside most of it's life as it is in very good condition. The seller said it runs good but I wasn't there when he drove it outside to park along the road. I know it at least runs as the muffler was still hot. All tires are junk and it...
  4. O

    930 spin on oil filter?

    Put one on my 1030...got it from a boneyard.
  5. O

    Control panel trim piece - where to find?

    Trying to find this trim piece -CIH says not available. 1896...assume same as 94 series.
  6. O

    Where can I get a large gas cap

    John - do you have the correct radiator cap for a 1030? I just have one from the auto parts store on now. Would really like the wide, chromed cap back on it... Thx.
  7. O

    Went Case shopping

    We had a 700 gas when I was a kid at home. My all-time favorite tractor. It would start at any temperature. I think I performed every task a dairy farm had to offer on that tractor. It was bullet-proof. I was one with that tractor.
  8. O

    Garden plowing fun

    Plowing with the 1961 830 and pull-type 3 bottom. Too much fun, needed a few more acres to get my fill. Plowing Fun.
  9. O

    case puller

    I was there and saw him pull - it's pretty impressive to say the least. He put 50-60 feet on the class. Was said he was clocked at 27 mph - whatever it was he was moving. Word is there is an engine shop in Ohio that worked the motor over - somewhere in the mid/upper 600ci range. He definitely...
  10. O

    how many do u have game ????

    Is there a pattern around on those front push bumpers? I sure would like to have one for my 530.
  11. O

    1896 front axle question

    Here's a pic I took while mowing today.
  12. O

    1896 front axle question

    Thanks for the reply. I have measured the arms and they are roughly the same and they are also very close to how my 2390 is set up. The Case mechanic wondered if it had the wrong tie rod on it but I don't know how to tell. Suppose I could try to get a measurement on a new one from the dealer.
  13. O

    1896 front axle question

    They are both in the same position relative to it's tire and the measurements are the same.
  14. O

    1896 front axle question

    There are just a few threads showing on the tie rod end on the other side, so can't take up much there, certainly not two inches. I've had several people look at it, including the dealer mechanic, and nobody has a clear answer. The cylinder is mounted to the axle so I can't just turn the...
  15. O

    1896 front axle question

    Pic
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top