(800) 853-2651
SHOP NOW

Recent content by old red m

Yesterday's Tractor Forums
  1. S

    Minneapolis Moline Z electrical question?

    Hello folks I have a MM Z that is 1937 I bought recently. Someone used it for tractor pulling so they removed the generator. They have the original starter with a 6 volt battery. Problem is that it's hooked up negative ground and positive for power to the starter. Can I just flip the battery...
  2. J

    MF 165 Power Steering Keeps Going Out

    I have a MF 165 that I have put three new pumps on and they keep going out. Luckily they have a one year warranty. They only last about 8 months or so with very little use on tractor. I replaced the linkages on the cylinder because they were wore out but didn't seem to help. The cylinder also...
  3. H

    Part for a MF 9318 floating bean head

    Does anyone have or know where to find the cast holder for the leaf springs under the bean head? The part number is 2607980 W1.I would think other heads would also have this if anyone is parting out a head. Thanks
  4. B

    3000 lift question

    Today I hooked up a tiller to my 71 3000 diesel and the lift arms will only go high enough to barely get it off the ground. Haven't noticed an issue with the lift per say but wondering just how high the lift arms should go when all the way up. I tried searching but didn't find anything really...
  5. Howard H.

    Hydraulic Control Valve

    Bought a really nice old Ford 1973 F700 grain truck a while back - and everything is great, except the cable to the hydraulic bed lift was broken. The widow lady said it worked fine, "you just have to crawl under there and tap it with a hammer..."... And was she ever right about that! I...
  6. T

    1926 Buda WTU rod connector torque

    Anyone know what the rod connector bearing caps should be torqued to on a 1926 Buda WTU? The cap bolts do have cotter pins. Tighten securely is all I could find. I do not believe the bolts have grade markings. Detailed specs on this low compression engine are here...
  7. O

    pull starting an M

    Hey guys maybe you can help me. I have an M that has been setting for yrs and I have put in a new battery, rebuilt the carb, new points(set propperly)new coil and new voltage regulator. Could not get it to fire with the starter and have pulled it it tries to fire but seems to backfire through...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top