-
O
70 rod specs?
My book has the center to center at 7 inch. The piston pin is .8592 inch, and the crank journal is 1.937 inch.- oliverpuller2
- Post #1
- Forum: Oliver, Cletrac, Co-op and Cockshutt
-
O
Farmall M hedder
W/W Custom Fabrication can make you one. Their number is 270-929-6827. I belive the guys name is Allen Ward. It"s been a few years since i talked to him, so if that number isn"t right I have another one for him.- oliverpuller2
- Post #1
- Forum: Tractor Pulling
-
O
4x4 oliver 77 engine
Has anyone took a 77 block and had it sleeved to 4 inch and had the crank underground to 4inch? I already have the crank done and I have the sleeves for the 4 inch bore. I was just wondering if you could get 70+ horsepower from this moter. It will run 2100 rpm"s and the cam is set up for that...- oliverpuller2
- Thread
- Replies: 0
- Forum: Tractor Pulling
-
O
310 gas big carb
I would talk with Motec Engineering, they build and rebuild carbs for pulling. www.motecengr.com- oliverpuller2
- Post #1
- Forum: Tractor Pulling
-
O
Clutches
Who is a good clutch guy or company, that can do custom work on clutches?- oliverpuller2
- Thread
- Replies: 4
- Forum: Tractor Pulling
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy