Recent content by otto berlin

  1. O

    ignition and resistor wiring on an 8n

    bruce, don, bob and bill, I really appreciate your response however here's where I am: a. i have replaced the distributor, points, rotor, 6v coil, ignition switch, resistor. ALL FROM YT b. I have had two other sources confirm that I am getting 6v to the coil but do not get spark to the plugs...
  2. O

    ignition and resistor wiring on an 8n

    don, just ordered resistor assembly from YT. Is the right one?
  3. O

    ignition and resistor wiring on an 8n

    bob thanks a million for the diagram. i now have a fighting chance of hooking the ignition and resistor (terminal block) together properly. Otto
  4. O

    ignition and resistor wiring on an 8n

    your assumptions are correct i.e. front mounted distributor, 6V, napa resistor replacement. therefore, the resistor gets wired to the coil and ignition. the ignition goes to the resistor and to ground. the lights go to the lights and to ground on the resistor. what does positive ground mean...
  5. O

    Wiring harness...what goes where?

    your wiring diagram (picture) of the 2N is fantastic. does anyone have a diagram for an 8N? really appreciate comments.
  6. O

    8N won't start

    have you tried bypassing the ignition by going from the top of the coil with a wire to the hot side of the battery? If this works, your problem is most likely the resistor. good luck.
  7. O

    ignition and resistor wiring on an 8n

    Help I am replacing the resistor but forgot the wiring sequence i.e. the resistor has two posts and the ignition has two posts. how do i wire the ignition to the resistor? Where can I find the electrical guide for an 8N? Thanks Otto
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top