-
P
1410 db pto verses rpm
I am using a friends 1410 on our round bailer , at what rpm is the pto giving me 540 the tach does work but no where does it give me this info thanks Dave- pa dave
- Thread
- Replies: 1
- Forum: Case & David Brown
-
P
wanted 1755 hyd pump
does anyone have a good used or rebuilt hydraulic pump for sale for a 1755 oliver < my local dealer seams to be having trouble finding one thx Dave- pa dave
- Thread
- Replies: 1
- Forum: Oliver, Cletrac, Co-op and Cockshutt
-
P
1755 hyd pump rebuild
can anyone suggest a company that could rebuild a vickers hyd pump off of my 1755 oliver ? THX FOR ANY INFO Dave- pa dave
- Thread
- Replies: 1
- Forum: Oliver, Cletrac, Co-op and Cockshutt
-
P
update on 1755 hyd pump
i did prime cooling pump and now oil is flowing trough oil colier , did notice on hi-pressure valve on the Tee fitting it is leaking as i can see little bubbles around fitting , my next step is to tighten all fittings on hi-lo valve , then we will go from there , the bubbles didn,t seam to be...- pa dave
- Post #1
- Forum: Oliver, Cletrac, Co-op and Cockshutt
-
P
update on 1755 hyd pump
i will have to reset the psi as wright now it is set at 2400 , my manual does explane how to check bleed off , something else i noticed when hyd oil got up to temp the oil cooling lines and pump wern,t even warm , could the cooling pump loose prim and if so how could you reprim it , manual...- pa dave
- Post #1
- Forum: Oliver, Cletrac, Co-op and Cockshutt
-
P
update on 1755 hyd pump
started on pump problem by r&r the pressure control valve, ball, springs , o-rings all fine , next i r&r the hyd pump bearings , and all internal parts looked fine , no nicks or gouges or groves from wear, r&r compensator valve all lookes fine , reinstaled all parts, instaled gauge according to...- pa dave
- Thread
- Replies: 6
- Forum: Oliver, Cletrac, Co-op and Cockshutt
-
P
hyd pump seizing
concerning hyd pump seizing i forgot to state that it is a 1755 oliver (1972) with 4500 hrs- pa dave
- Post #1
- Forum: Oliver, Cletrac, Co-op and Cockshutt
-
P
hyd pump seizing
has anyone ever had a hyd pump get so hot that it may seiz up an shut down the engine < seams after it cools down i can start engine again till pump gets very hot to the touch an happen again < pump has been getting noisier over last year or could this be a different problem , any info would be...- pa dave
- Thread
- Replies: 3
- Forum: Oliver, Cletrac, Co-op and Cockshutt
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy