(800) 853-2651
SHOP NOW

Recent content by Pa Farthing

Yesterday's Tractor Forums
  1. P

    8N Carb trouble

    It was a new needle so I polished it with 2000 grit paper didn't have an orangewood stick. lined up the float and put it back together. I could hear the float rattle. It started up now for the next problem. It seems to have a electrical problem. I think it is a timing problem. That is what I...
  2. P

    8N Carb trouble

    I am working on an 8N can't get the float to work right. I bought a new carb it was junk. I think the casting has a crack the drain plug drips, the float won't shut off the needle seat was stripped. So I bought a repair kit for the original carb. It had a different needle and seat it wouldn't...
  3. P

    ford doesn,t run right

    Working on a 8n .belongs to my grand daughter. When I got it the number one cylinder was dead. took a compression reading it was fifty lower that the other three.Pulled the head and changed the rings on that cylinder. Found some one had over hauled the motor .It was a complete over haul ...
  4. P

    how much oil

    Thanks for the info. There was a manual but when my grand daughter and the fellow she was with split up he took the manual. At least she got the tractor. I can get another manual.
  5. P

    how much oil

    Could some one tell me how much engine oil a 8 N holds
  6. P

    ford starter

    Went to my granddaughters today to put the starter on. I took the drain cock and oil dip stick out before I started. I could get the starter over the fly wheel but then I couldn't get the back high enough to get the nose to go into the tube it fits in. It was hitting on the oil filter. Its a...
  7. P

    ford starter

    I would like to thank every one that posted .By seeing the pictures I found out what it should look like. And that told me what I had and what I needed. From the pictures I figured out the drive was stuck in the extended position. So I'm guessing it was stuck in the fly wheel. Don't know how...
  8. P

    ford starter

    I,m working on a starter from a 8N . Does all 8N,s Take the same starter and drive. Also does the starter just slide back in I had a lot of trouble getting it out and part of it seems to be missing . There isn't any collar on the end of the shaft there is a hole for the pin but no collar...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top