-
J
Serial number ID
I have a Ford industrial 4000 the 2 sets of serial numbers are as follows, IN FRONT OF THE CLUTCH PEDAL on the engine block 41404D 49572 BEHIND THE CLUTCH PEDAL on the side of transmission C3NN-7006-B...- Jim Ch
- Post #1
- Forum: Tractor & Farm Talk
-
P
lift prolem
1940 9n I don t know if fixed because have not hooked up mower I did drained,removed top, inspection covers and pto shaft, cleaned out gunk refilled with new oil Pto turns and lift goes up and down If lift is either full up or full down how do you adjust the position of mower deck?- pabob2014
- Post #1
- Forum: Ford 9N, 2N & 8N
-
P
lift prolem
This is the problem I had while tiring to cut grass last summer. With mower deck set to height and pto engage the lift arms would raise until I had to shut down because deck would hit rear wheels. I took complete hydraulic system apart and cleaned system and changed fluid. Pto and lift work put...- pabob2014
- Thread
- Replies: 5
- Forum: Ford 9N, 2N & 8N
-
P
9N will not start with out jump
After two years of messing with this girl I found problem. and no were did anyone say anything about this. The coil mounts on top of distributor and has a pig tail which connects to points the other connect has a tab which connects to the cap Well this tab was not making contact with the cap. I...- pabob2014
- Post #1
- Forum: Ford 9N, 2N & 8N
-
P
9N will not start with out jump
9n changed over to 12v New points, condenser, wires, cap, rotor, plugs, 12v battery will not start unless jump with my truck Is 6V started robbing amps from ignition?- pabob2014
- Thread
- Replies: 4
- Forum: Ford 9N, 2N & 8N
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy