(800) 853-2651
SHOP NOW

Recent content by Patrick- OH

Yesterday's Tractor Forums
  1. P

    TO 20 shuts off after a few minutes

    It turns out there was ice in the gas. In freezing weather the ice would melt and the water in the gas would stall the engine. I put a bottle of heet in the tank in warmer weather and the engine would sputter a little until the water was gone. Tractor runs fine now. I love my tractor, but I seem...
  2. P

    TO 20 shuts off after a few minutes

    Thanks for all of the replies. I thought it might be the coil, but I replaced it 2 years ago. Back then it did the same for a while, then it wouldn't start at all. It was in the summer then. For my own knowledge, what causes the coil to fail after it warms up? As for dying when it is put under...
  3. P

    TO 20 shuts off after a few minutes

    I have started my TO20 a few times in this frigid weather. When it is warm it starts right up. I was able to get it to start after fooling with the choke until it was running for a few minutes. Then I would let it warm up for a few more minutes. It would cut out suddenly. No sputtering or...
  4. P

    PTO SHAFT OIL LEAK

    I am having the same problem. Recently started leaking from the PTO shaft housing. I assume that it is a bad seal. Where can one pick up a new seal?
  5. P

    Position Control Device

    Would love to. Unsure how.
  6. P

    Position Control Device

    I am interested in purchasing it. Thanks.
  7. P

    Position Control Device

    Could you please elaborate on the seperate fixed attachment point for the top link. Thanks.
  8. P

    Position Control Device

    Thanks everyone for the replies. I have a '51 TO-20. I am referring to the device that attaches to the finger tip lever/quadrant and the lift arms, which is used to hold an implement at a static height. I remember seeing the plans for one awhile back. Thanks Jeff. I don't have much time to...
  9. P

    Position Control Device

    Does anyone know where I can get a good control device for the 3-pt. Thanks.
  10. P

    L-UO-20 Manure Loader

    I am looking for a drop valve assembly for one of these loaders. Thanks.
  11. P

    L-UO-20 Manure Loader

    Does anyone know where I can get one of these valves?
  12. P

    L-UO-20 Manure Loader

    Hi everyone. I have a '51 TO-20 and I just picked up this loader for it. It came with an extra set of loader cylinders, but it is missing the drop valve assembly and the short hose that connects the drop valve assembly to the tractor hydraulic system. Does anyone know where I can pick one of...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top