(800) 853-2651
SHOP NOW

Recent content by Patsdeere

  1. P

    Farmall m starter switch

    I'll be dipped! Never thought it might be available new. Actually, never knew it was a thing back then.
  2. P

    Farmall m starter switch

    It's a local museum, not a high fancy museum... Tractor had been restored, but has normal dings/scratches that volunteers have added over the years. If you have one of these bracket things, I would bet they would be interested.
  3. P

    Farmall m starter switch

    Anyone have photos of what they did for the starter switch pushing? The museum I'm part of has a M, but there is a bolt through the steering post that then pushes on the starter switch. It's awkward for big footed people and can't be original. Thanks for photos/ideas.
  4. P

    Carb parts

    Thanks. I looked closer and it is a 41.
  5. P

    Carb parts

    Working on a dltx 13. The idle shaft has been cranked in and deformed the taper on the pin. Would like to replace, but if i can't find one, can I refile the one I have or should I get some drill rod and make a new one? If I make one, how does the rod come out of the top piece? Also the choke...
  6. P

    JD G electrical

    Thanks. This electrical stuff isn't my strong suit.
  7. P

    JD G electrical

    I'm regards to rate, that makes sense, but it should cut out when the battery is full. Run time is usually an hour or two to get to parades, then 2 hours through the parade and home. It has a cut out, little rectangular box, but maybe we should flip it all over to a VR.
  8. P

    JD G electrical

    Museum I'm part of has a late model G. It is currently set up with a generator and cut out and is 12v. I'm not sure what polarity is ground. It's currently charging at 16+ volts and doesn't seem to matter how long it has run, it stays up there. My assumption is the cut out has failed (looks...
  9. P

    Can you still sort the photo ads by state?

    That's unfortunate. I'm not going to sorry through hundreds of ads for the possibility of a CA ad.
  10. P

    Feeling a little proud here

    You are doing better than me. Those things are black magic. I just send mine out.
  11. P

    Back to my flat tire

    Maybe Mark the top of the tire when you find it flat and then park it that way a few more times. If flat each time, then park it in same orientation and start looking for leaks.
  12. P

    Flat tire on my Dodge 3500

    Had a family friend stop to help, ended up being beaten half to death and had his vehicle torched after they stole everything they could from him. Have to be careful.
  13. P

    Petition to move

    The paint forum back up to general versus being in the dungeon. I think it's as common as transporting and probably has more traffic. Or maybe there is a good reason it's down here..?
  14. P

    What am I doing wrong???

    Also depends on your browser settings. They can be set to hold the last view of the page for faster loading, but since it was the page that had new on it, it'll still say new. If you refresh the page then the new will go away, unless somebody has responded between the time you left the page and...
  15. P

    Re: Energy efficiency

    Nice.
See more
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top