(800) 853-2651
SHOP NOW

Recent content by Paul in Ms

Yesterday's Tractor Forums
  1. P

    1956 French built TEK-20

    It is a vineyard or narrow model. The radius rod and tie rod are made like that.
  2. P

    Is this a Ferguson TO-20

    It is a to-20
  3. P

    14-AO-40 Slat Moldboard Plow

    Price is good. The moldboard style share are hard to find and pricey.
  4. P

    to 30

    More hp in the to-30. Some changes in the rear end.
  5. P

    TO 20

    The axle seals on a to-20 will not last long and will be leaking on your brakes. Check out sureseals for a Ford 2 n 9 n they will also fit a to-20 . The axle bearing will have to be pressed off and most likely can not be reused. The sureseal fit over the bearing which has been greased with...
  6. P

    1750278M91 cast oil pan

    The cast pan I bought had to be trimmed off about 1/8 inch with a grinder to fit my to-20.
  7. P

    TO20 running problem

    Unscrew plug on bottom of carb. Make sure it has good flow. Check points gap. Check for fire at distubutor.
  8. P

    Ferguson plow share

    I bought a set of shares for my slatted plow from Scott . He has someone make them for him. They work great. They were pricey but good.
  9. P

    REAR AXLE

    install the shur seal. works great on to- 20 2 n 9 n. To-20 had weak outer seals new ones most of the time will not last long. I tried new seals on mine twice. Installed sure seals 13 years ago and still going strong.
  10. P

    TO20 trans/hydraulic capacity

    6 gals
  11. P

    TO20 clicks when starting. Replaced EVERYThING! HELP!

    every thing else has been asked. Have you checked voltage at battery.
  12. P

    Problems finding parts

    hd engine parts has a listing and in stock $26.00
  13. R

    spring water holding tank leaking

    i have a spring water holding tank made of concrete blocks that have some sort of inside sealer painted on them to keep the water in .it has has a crack about midway up letting water seep out slowly.they now make a plastic liner like a swimming pool liner that should seal it up.on the other hand...
  14. P

    oil seals for axle to-20

    The factory seals will not last long for what ever reason. The sure seals fit over the bearing assembly and is greased with axle grease. The sure seals are the way to go in my opinion.
  15. P

    fergeson 20

    The TO has the steering box and the shifter cover as two units. The TE they are one unit. The trans housing on the TO is cast iron on the TE it is an mag. alloy. The TO has Delco electrical. The TE has Lucas.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top