-
P
Fleetline push button
I strapped a solenoid to my 88 starter to prevent starter switch from burning up.- Paul V B
- Post #1
- Forum: Oliver, Cletrac, Co-op and Cockshutt
-
P
Pulley for 1850
The splines on ours stripped out 3 years ago. Korves found a used one on line for 300- Paul V B
- Post #1
- Forum: Oliver, Cletrac, Co-op and Cockshutt
-
P
Convert 6v to 12 volt system - Cockshutt 30
I had my generator converted to 12v. Used the old 6v starter.I strapped a starter solenoid to the starter. Kept burning up the push button starter switch after I converted it.- Paul V B
- Post #1
- Forum: Oliver, Cletrac, Co-op and Cockshutt
-
P
Bio Diesel; Is any Amount Good?
My Oliver mechanic claims bio diesel is made by adding something to regular diesel to make it bio diesel.He's seen all kinds of problems caused by using bio diesel where he lives. We have been using bio diesel from a different supplier in our combine and tractors with no issues whatsoever. He...- Paul V B
- Post #1
- Forum: Massey-Harris & Massey Ferguson
-
P
FE35 Perkins diesel bleeding
On my Perkins 354 engine we manually prime system to get most of air out. Then I open the bleed screw on the injection pump while cranking engine. Starts easy every time.- Paul V B
- Post #1
- Forum: Harry Ferguson
-
P
TO-30 was running good now not so much
Yes try a resistor. I have one on my 12v Oliver and TO 30- Paul V B
- Post #1
- Forum: Harry Ferguson
-
P
1650 Acts Like Running Out of Fuel
We had a big bug blocking the inlet to the fuel bowl one time. Caused your symptoms. Our perkins in the combine started starving for fuel too one time. Line was partially clogged with bean dust.- Paul V B
- Post #1
- Forum: Oliver, Cletrac, Co-op and Cockshutt
-
P
Oliver 550 only running on three cylinders
Check your point gap.I have a D17 that missed out terrible. Adjusting point gap helped a lot. Put electronic ignition in and now it runs perfect.- Paul V B
- Post #1
- Forum: Oliver, Cletrac, Co-op and Cockshutt
-
P
1550 hydraulic pump
The gaskets look similar to the hydrostat charge pump gaskets on our White 8700 combine. Easy to take apart and replace.The combine's shaft is smooth and has a keyway to accommodate a pulley.- Paul V B
- Post #1
- Forum: Oliver, Cletrac, Co-op and Cockshutt
-
P
Broken final drive axle
The final drive axle on our 8700 broke. Wasn't too hard to replace it with a donor.- Paul V B
- Thread
- Replies: 4
- Forum: Combines and Harvesters
-
P
Capacity, MF 750 vs 8560
Our White 8700 with the Perkins diesel doesn't smoke at all, 2350 rpm under load.- Paul V B
- Post #1
- Forum: Combines and Harvesters
-
P
Distributor problem
I had same problem with my D17 so I converted to electronic ignition. Runs great now.- Paul V B
- Post #1
- Forum: Massey-Harris & Massey Ferguson
-
P
points & cond.
I had my 6 cylinder tractor converted to 12 v. I still added an external resistor and haven't touched points in close to 20 years.- Paul V B
- Post #1
- Forum: Harry Ferguson
-
P
Cav Dpa injection pump, no power
Mine leaked at throttle stem also but I experienced no loss of power, just a messy leak.- Paul V B
- Post #1
- Forum: Massey-Harris & Massey Ferguson
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy