-
PMake that ROPS AND A SEATBELT! ROPS is only effective if also properly belted in.
-
PTop link too short ? Share worn Pictures
-
Ppaul replied to the thread part onfront of 4000 row crop.When trying to identify odd brackets, it really helps to know a location and what is done in the area the tractor came from. Saw a...
-
Ppaul replied to the thread What did I miss?.I find I post a few less messages since I’m tired of my email filling up. Wouldn’t need the email alerts from here. Paul
-
Ppaul replied to the thread a couple pictures from the Indiana State fair..Neat stuff. When I was a little kid I remember seeing machinery hill at the MN state fair. Folks didn’t travel much but we made it...
-
Ppaul replied to the thread triangle or trilobe pto shaft.When I was a kid used to be a lot of stock of square and triangle pto tubes at the farm supply stores. We must no longer use such raw...
-
Ppaul replied to the thread Can anyone help identify this hay rake?.Minnesota made one something like that. I’m trying to remember…. I’m trying to sort through the pictures on duck duck go and find a...
-
Ppaul replied to the thread Can anyone help identify this hay rake?.Looks like the one we had when I was a tyke, got replaced by a NH 55 before I knew what brands were, but I remember the rake. It worked...
-
PI don't see why they would be so different. The late 8Ns and the Hundreds had almost identical steering. And though an 860 is heavier I...
-
PThat sounds like you had JD's Equal Angle Hitch. Set correctly it makes it so that the u-joints are at the same angle during turns...
-
PIt's shameful that bureaucrats fine an 84 year old for elapse in memory and performance while rewarding 40 YOs sitting on porch doing...
-
PI have two of these laying around the place somewhere. One is worn out completely and one is in very good shape. I searched for a...
-
Ppaul replied to the thread More Bush Hog shear pin issues..This is a confusing issue/ thread. Shear bolt needs to be the right size for the hole. Usually needs to be tightened tight, not loose...
-
Ppaul replied to the thread Stripping 3000 for transport.Many years ago my brother in law had the tractor dealer pick up his tractor and deliver it again for some repairs. The bill for the...
-
PA 1500 chevy should have no problem hauling a ford 3000!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy