-
P
2N Timing
Thanks for the replies. After reading some more post I may have found part of my problem. I recently changed to a 12 volt system, but I'm using both resistors in series with the 12 volt coil. Is that correct? To clarify, I don't have problem setting the point gap, but the adjusting the...- PaulM1
- Post #1
- Forum: Ford 9N, 2N & 8N
-
P
2N Timing
I'm having a problem with my 2N. It does not to start well. I check for fuel and spark and they seem to be fine. I removed the distributor to clean, gap and check timing. When performing the general timing adjustment, I could not get the 1/4" between the straight edge and the mounting hole...- PaulM1
- Thread
- Replies: 6
- Forum: Ford 9N, 2N & 8N
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy