(800) 853-2651
SHOP NOW

Recent content by pcox

Yesterday's Tractor Forums
  1. P

    OT: 90 chevy van tension pully

    Pick up a performance engine magazine and check the ads, or look on line. You may be able to find an idler pulley to replace the AC compressor. Several years ago I was able to find one that fit the 350 engine in my brother's pickup. I didn't buy it, I was just looking for one at his request...
  2. P

    Any of you suffer with skin boils or carbunkles???

    I heard on a radio show put on by a doctor that boils, etc. are caused by a germ that quite often is found in your nose. He said that you could often get rid of them by putting an antibiotic ointment in your nose (using a cotton swab, not your finger!) twice a day for a month. Your mileage...
  3. P

    Good News on GMO

    Also be aware that people who OPPOSE GMO or something else will often do so blindly and out of ignorance. The BT insect killer is natural--do people who oppose BMO BT avoid any food where natural BT chemicals are present? Probably not. Monsanto does not own soybeans, only a strain of...
  4. P

    Shot guns and drones

    If a drone is an aircraft, then FAR would seem to apply. There are minimum altitudes that aircraft are required to maintain under FAR (see below, cut from Wikipedia). The problem will be identifying the operator of the drone to enforce the regulations. Begin Wikepedia text: In the US...
  5. P

    IH 470 disk parts manual needed

    Thanks for the input. I do have the Shoup catalog and have looked at the information on the Case IH web site. Both are good resources, but I would still like to have the parts manual, either a paper or digital version. Again, many thanks. Pat Cox
  6. P

    Can I drill the transmission case

    Wikipedia has a nice article on steel casting, including products made from cast steel and alloys used. Pat Cox
  7. P

    IH 470 disk parts manual needed

    My brother is rebuilding an IH 470 disk and it would help a lot to have a parts manual. I’ve searched the web and found only assembly and operator manuals, which did not have part numbers for things like bearings and scrapers. If anyone has a parts manual for sale, or knows of one, please...
  8. P

    O.T. water improvement tool

    My well water is highly acid, very hard, and high in iron. I finally had a Rayne system installed. Their web site is http://www.raynewater.com/. I am very happy with the system. Before it was installed, the iron in the water stained everything and settled out as sludge in the toilet tanks...
  9. P

    Need Some JD B Parts!!

    Sharp's (http://www.external_link.com) is a good place to start. I have bought from them in the past and been well satisfied. Pat
  10. P

    lincoln broken axle

    Bell Helicopter runs the output bearing of at least some medium weight helicopters against the main rotor mast. It is not necessarily a bad design, it just makes repair more difficult. By omitting the inner race, the rolling element bearing can be significantly bigger and stronger. Note the...
  11. P

    B parts

    I would be interested in the oil pump--how much do you want for it, shipped to Virginia. Email is [email protected] Pat
  12. P

    Cattle Markets LIMIT DOWN , Non GMO demand ???

    Anything peer reviewed, or just personal observations? Ever collect the runoff and have it tested? Might be interesting to see what the chemicals were, and the levels at which they are present.
  13. P

    Cattle Markets LIMIT DOWN , Non GMO demand ???

    Could you please post links to these studies, if they are peer reviewed? Thanks
  14. P

    Vermeer Model 605F baler bearing repair question

    Thank you. I will pass this information on to my brother. Pat
  15. P

    Vermeer Model 605F baler bearing repair question

    My brother has a Vermeer Model 605F baler. A bearing has gone out on one of the 3½” belt tightener rollers. How is the bearing removed? The book shows a retaining bolt with a large hex recess, but there is very little clearance between the roller and the side wall of the baler—not enough to...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top