(800) 853-2651
SHOP NOW

Recent content by Penntech

Yesterday's Tractor Forums
  1. P

    Massey 165 transmission noise

    Hello, I noticed over the weekend that our massey 165 has a whirling noise coming from the transmission. The noise is there when the tractor is in neutral or if its in gear it seems to get louder the faster you go. The tractor also seems to pop out of 2 high when going down hill. Does anyone...
  2. P

    Self employed health insurance in pennslyvania

    Hello, My Parents are self employed and are looking for a new health insurance provider. They are having trouble finding other insurance companies to deal with. So i was wondering if any of the self employed people here have any recommendations. Thanks for the help.
  3. P

    busted push rod

    They are 77 valve springs if I remember correctly. The engine has been together for 3 years now. Are you thinking to much spring pressure??
  4. P

    busted push rod

    hello, this past weekend I had my oliver 77 at a tractor pull and it started popping threw the carb. So we loaded it up and brought it home. Upon disassembly we found an exhaust push rod had busted in half and the intake push rod to that cylinder got bent. We tore the engine further down to...
  5. P

    Hydraulic flow restrictor?

    A smaller fitting will cause it to raise slower and drop slower since you are restricting it in both directions. what you need is a flow control valve which will allow the loader to raise at full flow rate but drop at a desired set speed.
  6. P

    dodge 5 speed death wobble

    Hello, I was wondering if anyone would have a 2wd five speed dodge cummins that could take a picture of the tranny cross member for me. I think it was installed backwards effecting the drive line angle causing a violent vibration at 40mph and up. Thanks for any and all help
  7. P

    2wd drive dodge cummins 1 ton death wobble

    Hello, I was wondering if anyone would have a 2wd five speed dodge cummins that could take a picture of the tranny cross member for me. I think it was installed backwards effecting the drive line angle causing a violent vibration at 40mph and up. Thanks for any and all help
  8. P

    Case 850 E wont turn left in high gear.

    Hello, I am working on a case 850E that will not turn left when holding the let brake in high gear. The left tract stops when you press the medal but the right track wont push. Also when you drive into a pile in high gear the right track stops. I am not sure what type of transmission this and...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top