Recent content by peostatim

  1. P

    International 4130

    Need help? I have a international 4130 skid loader with a cracked head? It has the original Onan NHCV engine. The part #170-3270 is stamped on the head. Does anyone specialize in onan or know where I could get a new or used head? Any help would be appreciated. Thanks.
  2. P

    SMTA

    I was wondering if anyone has ever put a M &W 9 speed in a SMTA. Will it work? How much of a difference is there between gears.
  3. P

    t-340

    Could be worth anywhere from $2500.00 to $6000.00. I have three of them so I watch them pretty closely. The last few I've seen sell were around $5000.00. The trouble with t340's is finding parts. Seems like they still pop up for sale once in awhile but if they need any parts good luck. To...
  4. P

    What's this worth?

    Peosta Iowa, I can e-mail or text pics with a phone number
  5. P

    What's this worth?

    I am posting this for a friend. It's a ford 8n (I think) chassis no wheels or motor or sheet metal. Just rear end with frame rails and front axel. He has been keeping it because it has a special bell housing adapter plate and extended frame and steering tie rods to mount a v8 or v6 engine. I'm...
  6. P

    IHC 340 6way

    looking for lower three point arms for t340. Can you help?
  7. P

    T-340 Value?

    All depends on the condition? A parts only machine can be anywhere from $1500.00 to $2500.00 and a good complete machine can bring as much as $4500.00 to $5500.00. Again it all depends on condition and what"s left of it. I have three of them and parts are getting hard to find.
  8. P

    FARMALL VOLTAGE REGULATORS

    I am having a terrible time keeping batteries charged. I"m starting to believe that my regulators are not working properly. When i restore a tractor I usually put a new regulator on and wire it correct to charge on the amp meter. Do i have to do something to the regulator to make sure its...
  9. P

    COIL - CONDENSER

    How do you properly check a coil or condenser to see if its good? Seems like alot of these get replaced when they don't need it.
  10. P

    T-340 crawler

    Eastern, iowa, however not afraid to travel or ship parts.
  11. P

    T-340 crawler

    I am restoring a t-340 ag crawler. Looking for some hitch parts. Does anyone know where their might be one sitting in a bone yard. I would like to find some crawler salvage yards. I just don"t know where to find any.
  12. P

    T-340 crawler

    I am looking for some parts for t-340 crawler. Does anyone know if there are any sitting in a bone yard somewhere. Specifically, I need the lower three point arms and lift cylinder. Any help would be appreciated.
  13. P

    farmall cub carb

    I just restored a cub farmall. It is running pretty good, but the throttle response is giving me trouble. If I ease the throttle from a idle up to working rpm very slow, it will run and rev up fine. If I do it with any speed or what i call working conditions it will kill the motor? Is this all...
  14. P

    FARMALL CUB ELECTRICAL

    I have a 57" farmall cub that i am restoring. I have everything electrical replaced. The 6 volt battery is weak, but still testing 6 volts. It will not turn the tractor over. It will just bump the starter and thats it. If i hook up a jumper pack it will turn it over like a sewing machine. Is my...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top