-
P
Belzona epoxy
Same here Russ,Saved a lot of down time and held up amazingly WELL !!! even Hi speed winder journals !!! -
P
injector pump
3249f0 that's the most # I can see without removing pump- petehall
- Post #1
- Forum: Tractor & Farm Talk
-
P
injector pump
I replaced the big fuel filter with Napa 3125,it had a rubber seal in groove as it is a spin on type??- petehall
- Post #1
- Forum: Tractor & Farm Talk
-
P
injector pump
Sir,It does run ,but No power or Rpm raise Its like a stuck throttle?? Just no increase in Rpms???? Thanks- petehall
- Post #1
- Forum: Tractor & Farm Talk
-
P
injector pump
I have a Perkins diesel with a Lucas,Cav pump Initially had a miss I repaced bad injector,all fuel filters and electric in line pump I can not raise the rpms to get good power I have adjusted the max rpm screw and rpms do not change even moving the little arm??? is there anything else I should...- petehall
- Thread
- Replies: 8
- Forum: Tractor & Farm Talk
-
P
Ford 335 hyd.
How can I prime the Hyd pump on a 335 Ford No plugs evident? Ive somewhat pressurized the resivor with air Any Ideas??? Thanks -
P
SAFETY FIRST
Geo you are CORRECT,You can never have too many Saftey features,loading and unloading My neck is fused and Im uncomfortable every time I un load !!!- petehall
- Post #1
- Forum: Tractor & Farm Talk
-
P
case 640 Hyd.
Thanks Barry for the help,Ill see what I can find- petehall
- Post #1
- Forum: Case & David Brown
-
P
case 640 Hyd.
Barry I try to get on Archives page and my computer wont let me cuz site isn't safe??- petehall
- Post #1
- Forum: Case & David Brown
-
P
case 640 Hyd.
A friend has a 640 Case diesel that the 3point works BUT bleeds off,dumping the hyd. fluid into the rear end and eventually leaks out the pto shaft Is there seals or ????? any ideas are appreciated !!!- petehall
- Thread
- Replies: 7
- Forum: Case & David Brown
-
P
Tankless Water Heater
I agree with everyone I had 2 high dollar instant heaters in my house I went back to regular propane tank heaters So frustrating trying to control the shower temp !!! Maybe they have perfected them ??????? -
P
Farmall Super C Coolant In Oil
ILL bet its one of the o rings on a piston sleeve Been there done that more than once !!!!- petehall
- Post #1
- Forum: Tractor & Farm Talk
-
P
mf 250 hyd problems
My hyd work at idle but as rpms are raised,they quit working??- petehall
- Thread
- Replies: 1
- Forum: Massey-Harris & Massey Ferguson
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy