-
P
Backfiring through Carburetor
Well, it would sure seem as though I"ve tried everything, with not much change in its behavior...still popping back through the carburetor while cranking....and not starting. I changed the point gap to .022" and attempted a start, still acting the same way. I checked the firing order...- Phil Simmons
- Post #1
- Forum: Massey-Harris & Massey Ferguson
-
P
Backfiring through Carburetor
Thank you all for your ideas and suggestions. Jerry/MT, you are right, a lot has been changed out, but it was somewhat methodical. I would change out a component, check for it to start, then proceed to the next item, like dist cap, plugs, etc. I always work on plug wires one at a time, so as...- Phil Simmons
- Post #1
- Forum: Massey-Harris & Massey Ferguson
-
P
Backfiring through Carburetor
Hello to all.... MH T0-35 (4-cyl gas) was running when it was parked. It hadn't been used much this summer..no rain. Anyway, it wouldn't re-start later the same day it had been used. It hadn't been tuned in a long while, so here is what has been replaced / checked: New Points set at .015...- Phil Simmons
- Thread
- Replies: 13
- Forum: Massey-Harris & Massey Ferguson
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy