(800) 853-2651
SHOP NOW

Recent content by pmurp57

Yesterday's Tractor Forums
  1. P

    1975 Ford 4400 tractor

    Thanks for all the wisdom this was a good sounding board I got to the root of the problem it was mostly, other people making changes to the carburetor linkages and governor rod length
  2. P

    1975 Ford 4400 tractor

    I agree I'm looking for a needle and main jet to put in so it can be adjustable I did hold the linkage steady and the timing is set to 6° according to the manual
  3. P

    1975 Ford 4400 tractor

    Have not been in side this carburetor not sure where to find new jets it a new zenith carb not built in the usa
  4. P

    1975 Ford 4400 tractor

    I did I'm getting ready to change the points and condenser I know carburetor icing is normal in the winter my Moline did is also
  5. P

    1975 Ford 4400 tractor

    Bought a new carburetor at Steiners installed it engine is hunting after it warms up and running rich, I see some carburetor icing
  6. P

    1975 Ford 4400 tractor

    Where's a good place to purchase a new or rebuilt carb id like something reliable
  7. P

    1975 Ford 4400 tractor

    Yep I'm looking at both of those ideas
  8. P

    1975 Ford 4400 tractor

    I read your post doesn't ring any bells for me I've read your post doesn't ring any bells for me, I worked on it this morning double checked my previous work it checks out fine starting play with the carb again and made it do other stupid stuff I believe it needs a new one
  9. P

    1975 Ford 4400 tractor

    Ok thanks I'll give that a try,
  10. P

    1975 Ford 4400 tractor

    It has never run correctly a couple different people worked on it I purchased it about 3 weeks ago would not stay running someone put plugs from a modern engine I believe they were Platinum gaped at .060 and were carbon fouled that also Frankensteined the carburetor combining a new carb from...
  11. P

    1975 Ford 4400 tractor

    Hello I need help with a 1975 Ford 4400 industrial tractor with a 201 motor the governor seems to be fully engaged, will edle if I disconnect the linkage. I started with the ignition system changed the coil set the points to .025 put the correct spark plugs in new cap and rotor, rebuilt the carb
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top