-
R
M Blocks
What is the minimum and maximum clearance from piston to cyl wall for 336 m block.Want to install a set on my U that I found.I really don't want to spend the money to sleeve them.- RA
- Thread
- Replies: 4
- Forum: Minneapolis-Moline
-
R
tractor tires
My U has 16.9/30 rear tires, I would like to put 18.4/30 will they fit ok on the same wheels.- RA
- Thread
- Replies: 2
- Forum: Minneapolis-Moline
-
R
LP Replacement Regulator
Impco or woodward which one would be the best replacement for the ensign.- RA
- Thread
- Replies: 4
- Forum: Minneapolis-Moline
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy