Recent content by Ragnarok

  1. R

    Groaning shudder when truck heavily loaded?

    Sounds like the clutch packs are worn and slipping in the trans
  2. R

    Another tool find...

    Snap On heel bars missing the small one...I just bought a new set off the truck...around $300 on sale....I've owned a set of those since the 1980's
  3. R

    54 Power Wagon engine?

    My son has drug up a more or less project truck....a 54 power wagon. It's a needy project and needs a serviceable 230 CI flat head engine.... Has been tough hunt for a good rebuilder engine so far....I got to thinking a bunch of those old Massey 82/92 combines and other ag equipment were...
  4. R

    JD 300 back hoe Carburetor solenoid delete

    You can buy a brass manual adjustment valve that replaces the solenoid valve
  5. R

    Splitting 4430 Cabbed Tractor

    I use a ten ton floor jack myself to hold the rear up....custom(home made) front stands made from heavy trailer screw jacks that are height adjustable and have wheels.... I spent 20 years in a JD dealer shop and have seen half a tractor hit the floor!...It ain't pretty!
  6. R

    JD 4200 gears whine/drag

    Is that a pedal hydrostat 4200 tractor?....I thought those use JD Low viscosity hydraulic/trans fluid? The cheap yellow bucket '303' fluid is not for anything JD much beyond 1973 and newer. It meets the old JD specs not the newer stuff....fine for your log splitter...I would not put it in a...
  7. R

    2020 loses hyd.

    Trash on the suction screen....lots of debris probably from a previous issue as it all looked like old stuff. A closer inspection of the machine shows the left final drive has been off at some point in the past. My guess is that either the planet gears or axel bearings went out(or maybe blew...
  8. R

    JD 261 Grooming Mower Rear Wheel Assembly Arm

    I own an older JD261 grooming mower...pretty good old mower for my little Allis tractor
  9. R

    2020 loses hyd.

    Hmmm...not a hyd. pto has a dual stage clutch and pto shift lever. I've done those steering column o"rings before!...They are awesome. I did not mess with the friend's 2020 much today. I did start it up and check to see if the hydraulics were working cold today like they did...
  10. R

    Clutch disc

    Usually towards the flywheel...but check the new disc....most are marked 'flywheel side'
  11. R

    Graphite Rods and Brazing

    I was born and raised poor....my father would weld that up bead after bead and grind it out...he would likely weld-up the pin too!
  12. R

    2020 loses hyd.

    Another thing I thought I might check would be the pump drive shaft a key(looked at JD online parts)....I had a 4440 strip the splines from the pump drive shaft last summer....but it lost it all at once and no more until it got a new shaft
  13. R

    2020 loses hyd.

    Three point works and stays up...but I will check it out. Loader valve is plumbed direct and returns to the filter housing.
  14. R

    Graphite Rods and Brazing

    I've taken stuff like that to the local machine shop and had it bored and sleeved back to size...helps if ths shop has a good center pin to measure
  15. R

    Wheel sticking on IH 560

    Bendix brakes....lots of tractors use those or variations of the Bendix type brakes. Seems like you could buy a kit at one time with new balls and springs....but I'm thinking that was for a Case
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top