(800) 853-2651
SHOP NOW

Recent content by Ralph Newton

Yesterday's Tractor Forums
  1. R

    Case G310E Dozer SN2016229

    I will take it. Thanks
  2. R

    Case G310E Dozer SN2016229

    I got the original operators manual with it, I need to get a service manual, didn't find any on this site.
  3. R

    Case G310E Dozer SN2016229

    3016229 is correct, I hit the wrong key.
  4. R

    Case G310E Dozer SN2016229

    Can anyone tell me where I can find a wiring diagram for this dozer. I purchased this thing from a guy that had it setting in a old hog house and hasn't been started in 40 years. It show 210 hours which is hard to believe but the man said that was correct and I can't find any wear on it just...
  5. R

    1951 A John Deere Transmission

    You guys are good, I want to thank you for the suggestions. It was the bearing in the clutch pulley dirty and dry, I cleaned bearing and packed it and shined the shaft up and sounds good now. Thanks All
  6. R

    1951 A John Deere Transmission

    I just went over and tried it and it does not feel rough turning by hand. What is the plug in front of the clutch handle? It looks like a oil plug.
  7. R

    1951 A John Deere Transmission

    I was gone today, but did check and the governor is quite and I think it may be the pulley bearing as you suggested. My book shows a clutch prior to SN 648000 and mine is after that. Where does the pulley bearing get its Lub oil, from the crankcase or I saw what looks like a oil plug in front...
  8. R

    1951 A John Deere Transmission

    I will check the governor in the morning. It makes the noise all the time, with the clutch disengaged, PTO off, and the transmission out of gear. That is why I was trying to find out if anything was turning in the transmission. Some times it will sound like something is catching and the belt...
  9. R

    1951 A John Deere Transmission

    Could part of the governor bearing wind up in the transmission?
  10. R

    1951 A John Deere Transmission

    I have been restoring an A John Deere. I found a round ball bearing on top of the drain plug when I went to change the oil in the transmission so I'm sure I have a bearing problem there, but I get this vibration and noise when it is running with the clutch disengaged or driving the tractor in...
  11. R

    Rick Cohn

    I purchased a starter from Rick Cohn for a John Deere A. I am happy with the starter and fast shipping. Ralph
  12. R

    1951 John Deere A Starter

    I sent you a email
  13. R

    1951 John Deere A Starter

    Can someone tell me where I can find a starter for a 1951 A or where I can get one rebuilt? Thanks
  14. R

    Ford 3000 gas 1970

    Thank everyone. I have it running good now, hope it stays that way. I remembered tuning a tractor up several years ago with new points plugs and condenser and the tractor didn't want to start and would run long when it did, I started putting the old stuff back and when I got to the condenser...
  15. R

    Ford 3000 gas 1970

    I have checked for air leaks, I took someone advise here and sprayed starting fluid around it when it was running to see if it would speed up. Fuel lines and filters have been checked. I pulled the fuel line off at the carb and turned the engine over and fuel shouts out about e inches, I'm not...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top