(800) 853-2651
SHOP NOW

Recent content by Randy K Crump

Yesterday's Tractor Forums
  1. R

    JD A manifold

    JD A 1951 - exhaust/intake manifold. Do any of the stud bolts go into the water jacket in the head or are they all a dead end hole? Secondy, what is the torque of the stud bolts? Third, should I use any gasket adhesive on the exhaust/intake manifold gasket? THANKS!
  2. R

    JD A Starter

    JD A 1951 - Based on the responses I received regarding my problem with getting the starter installed, will I be able to install the pin and cotter key for the small hook that goes on the end of the starter for the rod? There does not seem to be much room in back of the flywheel. Looks like...
  3. R

    JD A Starter

    JD A 1951 model: I am having trouble getting the starter to go through the left hole to the flywheel. I have the two wires on the copper tongue and the wires through the top hole. They are new wires and don't bend very easily. Any suggestions would be appreciated. THANKS!
  4. R

    JD A Slips Out of Gear

    JD A - 1951 model year: Tractor will automatically slip out of gear when it is in second and third. It might do it in other gears also. I am restoring the tractor and have it all painted and ready to be put back together. What is the problem and is it easier to fix before I assemble the...
  5. R

    Ford 8N Hydraulics

    My Ford 8N can't keep the Woods 5 foot mower at the correct level. It is either too high or too low. If I get it at the correct height, sometimes tall grass will pull it down. What needs to be repaired? Is there a manual on how to do the repair? THANKS!
  6. R

    Gas Can

    Where can I purchase a 5 gallon gas can with an old fashioned open spout? I don't want any of the safety features that are on the new cans.
  7. R

    Ford 2N 8N seat

    I am looking for a seat that is flat and does not have the hump in the middle/front for my 2N and 8N. Is there a seat on the market that is available?
  8. R

    JD Z445 Left hydro motor

    On my Z445 it has a Tuff Torq hydro motor part #787Q0824000.
  9. R

    JD 70 Grill Housing Installation

    No I am referring to the bolt that goes through the grill housing on the side then goes through the bottom of the hood.
  10. R

    JD 70 Grill Housing Installation

    JD 70 grill housing middle side bolt that attaches to the bottom of the hood. Based on the parts book, I know the order of the hardware but it does not show what hardware goes between the grill housing and the hood. Does the rubber washer go between the grill housing and hood or on the inside...
  11. R

    Ford 2N Cultivator

    When my Dad purchased his new 1945 Ford 2N, he also purchased a three point cultivator. I have restored the tractor. The cultivator needs to be restored, i.e., needs new shoes, paint, etc. Does is have any value? Are shoes available for this cultivator? I doubt that I would ever use it...
  12. R

    JD A 70 Axle Color

    JD 1951 A and JD 1954 70: I painted the rear axles on the inside of the wheels black. Should the axle that is exposed on the outside of the wheels be painted black or yellow? I have seen restored tractors painted both ways. Thanks!
  13. R

    JD 70 Wiring Diagram Needed

    I have a 1954 JD Model 70. I need to know the proper wiring from the amp gauge to the ignition, distributor, coil and generator. Does anyone have a wiring diagram for the dash that they could share with me? Thank You!
  14. R

    8N Voltage Regulator

    8 N origianl 6 volt system. I have been through 4 voltage regulators over the past 2 years. The last vendor said to spray WD40 inside before installing. It worked about 6 months. I polarize them as per instructions. Tapping on the cover does not help. I am paying about $35.00 for them...
  15. R

    JD A Shutters

    I am restoring my JD A. I cleaned up the shutters and they work great. I am concerned if I spray paint the epoxy primer and urethane paint on them they will no longer move. If I tape all of the moving rods, etc., there won't be much to paint. I wonder if I should brush the primer and paint...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top