(800) 853-2651
SHOP NOW

Recent content by RandyC

Yesterday's Tractor Forums
  1. R

    What Horsepower Is This Briggs Engine

    This is a 27.0 HP engine according to the numbers you have.
  2. R

    15 Cent Carburetor

    They are all sold out now
  3. R

    Using heavier gear oil in a super dexta

    If it was me I would wait and get the proper oil if it calls for 80w90. If it had some water in it I would flush it out before you add the oil.
  4. R

    550 Clutch Safety Switch

    I don't believe it threads in but I think the lower end is held on by a pin. I would have to drive out and have a look at mine to be sure.
  5. R

    550 Clutch Safety Switch

    I dont have a picture on hand to send but the rod has a bend in it so it will fit in there and line up.
  6. R

    Fun project

    Looks like a lot of work and a real nice job.
  7. R

    Cockshutt Paint

    I would say Napa should have the paint. I don't have any paint codes though.
  8. R

    Logs me out

    When I'm in classic view I have no problem When I clicked modern view it logs me out. So I log back in then I will come back later and I'm logged out again. I can stay logged in on classic but not modern is this normal or is it just me ?
  9. R

    Removing Rims

    I'm not sure what you want to do maybe to take inner and outer rim apart. I would use a torch and heat it up real good then get a big hammer.
  10. R

    Wiring a DB- Electric Alternator on a 1265

    I would ask how to wire it from where you bought it maybe they can help you.
  11. R

    need non tractor help with a Dodge pikcup

    Its been a long time since I worked on them I think it will work you may have to change the mount. I can't say 100% it will work but if my memory says it will work. I suggest to measure the spacing on the transmission before you start. Wish I could tell you for sure.
  12. R

    JD300 Backhoe Loader Spark Plug Overheating

    White smoke coming out the spark plug hole ? Was the plug loose ? So before this was everything fine ?
  13. R

    Bead was leaning on my rear tire

    When I worked at a garage we used grease to help seal the bead on old tires. Just smeared some around tire bead most times it worked.
  14. R

    Compression

    I think it is 80-100 psi
  15. R

    Anti-freeze in crankcase.

    Adding something to try and fix your problem will be a waste. It could be the gasket or cracked head or block. I think you will have to pull the head and see what has happened.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top