(800) 853-2651
SHOP NOW

Recent content by real_lifer

Yesterday's Tractor Forums
  1. R

    TEA-20 Governor

    I cannot understand why people are asking you to contact them via an email address.... This is a little suspect to me... The idea of a forum is that we share information... If you can't share the information directly .... get off the forum!
  2. R

    Ferguson Tea20 Block

    Hi All, Anyone got a good block they want to sell??? Locality = Toowoomba QLD, Australia Pulled the head of mine and there is hole in pistons 4 and crack across block between 2 and 3 and crack in water jacket between water drain tap and back of block... So since I have the head off might...
  3. R

    Front crap trap????

    Hi All, I am in the process of reconditioning a TEA20.. When I looked at the front, under the mains fan pulley it is just full of crap... It took me like 2 hours too clean all the crap out... Why is there not more drain areas or a hole in the base??? Has anyone modified this??? Regards...
  4. R

    Front crap trap????

    Hi All, I am in the process of reconditioning a TEA20.. When I looked at the front, under the mains fan pulley it is just full of crap... It took me like 2 hours too clean all the crap out... Why is there not more drain areas or a hole in the base??? Has anyone modified this??? Regards...
  5. R

    Ferguson Carry-All

    Hi All, I have a plated Massey-Ferguson carry-all that I want to restore to original condition... Would this have been Ferguson Grey or Red??? Made in Australia.... Model = 12 Serial = 7523 Thx for input Rod
  6. R

    Stat Carb Settings for Zenith TEA20

    Hi All, Re built carby... What screw settings should be a good start???
  7. R

    Original Seat Bolt

    Hi All, Has anyone come up with a solution to replace the original seat bolt? Part number 1221 It was a domed top square keyed 7/16 bolt about 25mm long. Has anyone found a supplier??
  8. R

    More than a Head water Leak TEA20

    Just don't know where to go with this... I can get an 2nd hand block for $300... Rebuild kit for $500... I can do the work.. Rebuilt plenty of engines in my time... So add another $300 for grinds an hot tanking etc... Is it worth $1100 - $1300 for a reco engine??? The rest of the unit...
  9. R

    How to Identify my Fergy without serial plate

    Hi, I have a Ferguson TEA20 (I think) There is no serial plate... I have identified date stamp under seat as 3/6/2 Which I believe equates to 03/06/1952 The engine I believe is original because the date stamp behind the generator/carburettor is 9/12/1 Which I believe equates to...
  10. R

    More than a Head water Leak TEA20

    I have been told Chem-I-Weld is a good option for water jacket cracks... I think I will try this before pulling the whole engine out...
  11. R

    More than a Head water Leak TEA20

    :cry: Seems on further inspection after buying the tractor that there is a waterfall down the manifold side of the block. There is a hairline crack that runs behind the carburettor and along the block for about 25cm doesn't go right to the rear of the block but possible goes to the front...
  12. R

    Ferguson TEA20 HeadLeaks Water

    Hi All, Is there a plate/flange or something at the rear the cylinder head that can leak water?? I am looking at what looks like a metal plate at the rear of the head slightly off centre to the manifold side. The guy I bought the tractor off has plastered it with some plastic steel but it is...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top