-
RIt was parked because dad said gears were stripped. I know it will run if I restore parts removed while my brother was working on the...
-
RRedMVa replied to the thread Skid steer adapter on ih 574.You may be right about the bucket , but I say it’s a foot too wide. The front rims have been turned so the tires stick out farther and...
-
RRedMVa replied to the thread Skid steer adapter on ih 574.^^^^this now that we see it. As far as cylinder end slop, you could get bushings put in them and new pins if needed. Bucket is too big
-
RRedMVa replied to the thread Skid steer adapter on ih 574.Buy one or make one , remove bucket and attach the quick tach. ur MN will probably be along with more specific details. I don’t know if...
-
RRedMVa replied to the thread Power steering pump on a 52 super m.Yep , it’s from a ford car or likely a truck, so it’s motorcraft
-
RRedMVa replied to the thread Why does oil come out of this area when I crank over the engine?.You didn’t need to quote me on that hahaha, and if he doesn’t know he has to remove what’s there to put the correct plug in it well then...
-
RRedMVa replied to the thread Why does oil come out of this area when I crank over the engine?.Put an oil galley plug or just a plug of the right size in it
-
RRedMVa replied to the thread Virginia State of Emergency impact on farms.Yeah you’re up the valley, up close to Winchester I haven’t seen a fall harvest this good in a long time. 1st cut was half of normal...
-
RRedMVa replied to the thread Wiring a Hustler zero turn help.Very simple, solenoid needs power from switch when you turn it on and power killed when you turn it off. Easy to check wires off...
-
RRedMVa replied to the thread Champion Generator.That’s what clearance is on fc150 Kawasaki .0047, set at .005. Not scary, just what it is, set one yesterday
-
RRedMVa replied to the thread new Zero turn mower choices.Yeah they are just like a regular zt, last one I worked on was 3-4 years ago and I can’t remember how the joystick worked. It had a...
-
RRedMVa replied to the thread new Zero turn mower choices.That joystick is ok , if you can get used to it. If it was all that , other manufacturers would be copying it. They aren’t, and country...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy