(800) 853-2651
SHOP NOW

Recent content by ReMarkabel

Yesterday's Tractor Forums
  1. R

    O-ring

    Thank you Dennis Ill give that a go. If anyone else out there has experience with replacing the Hydraulic feed tube o-ring as to its part number and Perhaps its demensiions; ID OD and CS that would be helpful! Thanking all in advance!
  2. R

    O-ring

    Please advise as to a sourse to purchase O-ring for hydraulic feed tube to lift cover for FSM. Thank for any info
  3. R

    Vacuum governor

    Thanks to Phonostud! Darwen Diesels had the damping valve, were a pleasure to do business with and now my FSM is humming like a well fed kitten! This is an excellent forum and an additional shout out to Majorman who has advised me in the past. Stay well all and heres to looking forward to...
  4. R

    Vacuum governor

    Tom: Thanks for the reply. Appreciate it!
  5. R

    Vacuum governor

    Thank you, Tom. I'll check it out. Any thoughts on the symptoms I related as to the worn out dampening valve? All feedback greatly appreciated!
  6. R

    Vacuum governor

    '61 FSM serial #1602957. Difficulty starting w/o touch of starting fluid. Hunting at high rev. Lots of white smoke. Suspected diaphragm in vacuum governor. Disassembled and found diaphragm in good order,however; found dampening valve out of place in body of governor housing and upon...
  7. R

    FSM hydraulics

    Majorman: Thank you for your insight. Majorman: Thank you for your response and insights. I will explore that and as they say, "the plot thickens!"
  8. R

    FSM hydraulics

    SkipperII: Hey! Thanks so much for the timely reply. Much appreciated. I'll move forward with the 30wt. then and if no improvement progress with the insights you suggested. I'll post my outcomes as they develop. Stay safe and well and thanks again!
  9. R

    FSM hydraulics

    Having trouble with lift consistency. Starts out strong but as work progresses lift loses strength and full range. Drained rear and cleaned wire mesh screen. Had SAE 90 in and changing to SAE 30 H.D. as many in forum have suggested. Question: will residual 90wt be incompatible with the 30wt...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top