Recent content by renegag

  1. R

    2-60 white hydraulics

    yeah I know it could be a little slower but I am wondering how much slower... I think I'll just plumb it temporarly into the remotes and see how much difference there is. Thanks guys!!
  2. R

    2-60 white hydraulics

    Hi, I have a rear mounted pump just on top of the pto to run the loader in front along with a separate hyd. tank, and the original engine mounted pump for the pto and remotes at the rear wich use tranny oil. Now the rear pump for the loader is only running with the pto engaged so everytime I...
  3. R

    2-50 or 2-60 White

    I have a white 2-60 all wheel drive, kmw loader and cab, they are reliable and quite easy to maintain if for the front axle, parts are available but rare, if a 2wd then I never had any problems finding parts for the steering if good and powerful on one side i guess it,s just a matter of...
  4. R

    Massey ferguson 110 spreader- couple questions

    Didnt even noticed it was wider at the back lol... Thank you!
  5. R

    Massey ferguson 110 spreader- couple questions

    Hi, just acquired an old mf 110 manure spreader, in pretty good shape, except for a couple of floor chain crossbars that has been reinforced or bent. Any info on that model of spreader would be greatly appreciated... first question. should I lube the the chain drive gear with grease or clean...
  6. R

    MF165 planetary gear oil

    yes same oil as the transmission, or 80w90 would be fine also, this is what was in mine when i bought it. tranny must absolutely have permatran or equivalent tdh oil for the hydraulics and multipower/ipto clutch if ou have it, so my opinion is your best bet is to put engine oil in the engine and...
  7. R

    165 brake issues

    Thanks guys, I will recheck everything and maybe put new actuators in as well
  8. R

    165 brake issues

    I put some new discs in, wire brushed all the contact surfaces and took apart the actuators, sanded the ramps, balls, and the springs were or seemed good, all the linkage were free and showed no major wear. the old disc were welded on the axles with rust, but I cleaned everything up with a wire...
  9. R

    165 brake issues

    Hi, i did replace the brake discs in the old 165 last fall, only on the left side and figured I would do the right side this summer. the plates were almost welded to the shaft with rust, but other than that the actuator itself didn't seem to be worn out too much so I cleaned it and reassembled...
  10. R

    2-70 pushes water out at idle

    could be a head gasket or cracked head, When engine is at operating temperature the crack or leak would close due to the expansion of the metal... just a tough
  11. R

    White 2-60 cab heater hoses

    Yes the cab was manufactured by a company named Laurin so it is not the original but I think that there was a cab on these as an option. Thanks for your input!!
  12. R

    White 2-60 cab heater hoses

    Hi, I would like to know how to correctly plumb the cab heater on the engine, right now there is a circulation water heater on it plumbed on the side of block and lower radiator hose elbow I think, and the cab heater is connected exactly where the temp sensor is supposed to be on top of the...
  13. R

    1950 H live pump conversion??

    Hi, I'd like to install a loader on my H to unload hay bales and would like to have a live pump, I know there are several posts about this but I would like to know what is needed exactly. I know I need another camshaft gear and another timing cover and a pump. I plan to remove the belly pump...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top