-
R
Pressure plate adjustment Ford 641
Well isn't this interesting. Distance from front of the bell housing to the release bearing face with petal down is 5 1/32" when bearing is even with the end of release bearing tube(6 12/16" petal up.) Distance from block surface to pressure plate fingers is 5 14/32". That means fingers are...- Rex Clonts
- Post #1
- Forum: Ford
-
R
Pressure plate adjustment Ford 641
Thanks for answering. Clutch disk is mounted correctly with hub away from the flywheel. Ill split the tractor tomorrow (3rd time) and let you know those measuments.- Rex Clonts
- Post #1
- Forum: Ford
-
R
Pressure plate adjustment Ford 641
Is there an adjustment for finger height on a NDA7563A pressure plate? Replaced the worn-out clutch in my 641 with a new kit including the 10"-10 spline clutch disk, release bearing, pilot bearing. Everything went back together fine. It will not release. I've adjusted the petal height and free...- Rex Clonts
- Thread
- Replies: 4
- Forum: Ford
-
R
Pressure plate adjustment, Ford NAA
Thanks. I'll take your advice and post in the Ford column.- Rex Clonts
- Post #1
- Forum: Ford 9N, 2N & 8N
-
R
Pressure plate adjustment, Ford NAA
Is there an adjustment for finger height on a NDA7563A pressure plate? Replaced the worn-out clutch in my 641 with a new kit including the 10"-10 spline clutch disk, release bearing, pilot bearing. Everything went back together fine. It will not release. I've adjusted the petal height and free...- Rex Clonts
- Thread
- Replies: 3
- Forum: Ford 9N, 2N & 8N
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy