-
R
load fastening
You said a mouthful...I had a drunk run a blind intersection 110mph into my trailer about 1AM 15 years ago-totalled a 40 ton lowboy and the 4020 on it. All the chains held but they guillotined 3 of the 4 tractor axles...7 major pieces of the tractor 350 ft out in a stubble field. Another time...- rgraven
- Post #1
- Forum: Tractor & Farm Talk
-
R
load fastening
I've been hauling heavy equipment with DOT authority since 1970. The law on any wheeled or track vehicle over 10000 lbs is four grade 70 chains pulling four directions.. In the US they can be 5/16 or 3/8 as long as the total rating of the chains is 1/2 the total load...Canada you must use 3/8...- rgraven
- Thread
- Replies: 5
- Forum: Tractor & Farm Talk
-
R
MM Power units
It is a 605. I didn't know that they made them in gasoline-knew they made LP, natural gas and diesel, other than the fact that they were hellish good irrigation units I don't know a lot except keep the rpms stock(1500-1550) or they don't live long. I imagine the puller guys would love to get...- rgraven
- Post #1
- Forum: Minneapolis-Moline
-
R
drove my MF180 diesel into the pond
Look and see if the linkage from the shifter for hi/lo is moving as far as it should...try unhooking the clevis an the trans end and operating it . You can"t start a multi-power tractor by pulling it but you can"t hurt them by pulling either unless you had it in reverse or pulled it backwards...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy