-
R
12 volt conversion
Just installed new starter solenoid on my 8N with no results. Put in on with small terminal facing outward. Didn't know it made a difference. Why would it? Will turn it around tomorrow and try again. Thanks for the suggestions.- rmor
- Post #1
- Forum: Ford 9N, 2N & 8N
-
R
12 volt conversion
I recently installed a 12 volt conversion kit (purchased from Yesterday's Tractor Co.) with a one wire alternator. I followed the supplied wiring diagram and now it won't click, clack or even start. I have power to the alternator with the key off, as well as the starter relay (it dosn't click)...- rmor
- Thread
- Replies: 10
- Forum: Ford 9N, 2N & 8N
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy