(800) 853-2651
SHOP NOW

Recent content by rob in nh

Yesterday's Tractor Forums
  1. R

    '51 farmall cub transmission

    check the reverse idler gear for sloppiness in the shaft.
  2. R

    air fed respirator

    Try putting the hose at ground level and about 5 or 10 feet away from the building, thats what I do with mine and have no problems.
  3. R

    Hardener for CaseIH Ironguard paint?

    Hardener will definitely make the paint better. I use it all the time. It will be more resistant to fading and resistant to chemical spills.
  4. R

    Torn over what paint to choose!

    That paint had to been bad , you should call your paint rep and have him check it out.
  5. R

    Enamel cure time

    That looks really nice.
  6. R

    Enamel cure time

    I was also told by the paint rep that using lacquer thinner with hardener slows the cure time way down.
  7. R

    Enamel cure time

    . I was told by my paint rep that the curing will stop below 60 degrees, I would keep the heat on as long as you can.
  8. T

    Torque amplifier International 350U gas

    Hi, I just cracked open my 350 utility gas tractor project. It needs a lot of work including the low side of the T/A. This is what I decided to tackle first. I do have a service manual but have never done a T/A before. What do you guys recommend?? What actually fails? The tractor sat a...
  9. R

    Paint Finish Went Dull Overnight

    Thats discouraging, all the labor it took to get it ready and you end up with that. I would use a automotive paint next time, be a much better job.
  10. R

    High temp paint.

    i just finished a cub and used epoxy primer then top coated with urethane enamel. I've found that the high temp paint doesn't last so i thought i would try something different. Its only has about 4 hrs on it and so far it looks good.
  11. R

    Question about Imron 3.5

    I would think it not solvent pop . It sounds like fish eyes to me or possibly water in the lines. Your regulator/water separator should be at least 25 feet from your compressor.
  12. R

    Question about Imron 3.5

    How close is your air regulator/water separator to the compressor? If its close to the compressor it can cause water problems.
  13. R

    Question about Imron 3.5

    What about water in the air lines?
  14. R

    I have been offered up a gift

    Its probably going to cost more to fix it than to replace with a modern one.
  15. R

    Majic paint on a Farmall Cub?

    I wouldnt use it, I would get an automotive acrylic enamel. Its a longer lasting paint especially if you use a hardener. Keep in mind that you need a air fed respirator when using hardener.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top