(800) 853-2651
SHOP NOW

Recent content by Robbie Gooch

Yesterday's Tractor Forums
  1. R

    Leroi Centaur

    Hey everyone, my name is Ryan, and I have a Leroi D-140 Centaur tractor in need of some parts. I am needing the rear main bearing cap, main bearings, and a set of thrust washers. If anyone knows of anything or any place to have new ones made, buy NOS, or used, please drop a reply, or email me...
  2. R

    2840 hydraulics

    Yes, pump coupling is new. PTO, HI/LO and brakes work fine. You can feel/see the hammering in the steering, 3 point and remotes
  3. R

    2840 hydraulics

    I have a 2840 and the hydraulics have started hammering. I've heard this is a common problem with these tractors. Is there a common cause of this? I've already drained the fluid, cleaned the strainer/screen and replaced the filter with little change.
  4. 2

    Oliver 1950 build Card way off

    Just got the Build Card for my 1966 (I think) Oliver 1950. According to the Build Card was a retuned tractor after being sent to A Growing O show. but the Card shows it to be MFWD (its not). 23.1-34 tires (they are 18.4-38). 1000 only PTO (its dual speed). The Card also shows Crown Fenders, but...
  5. G

    Case 530CK Case-o-matic fill

    Hi, this is a 1964 530CK diesel I found the dip stick hidden under dash on right side. (photo 1) - just would like to know where the fill point is I did notice the big nut on right side is this COM fill point (photo 2) - is Dexron 3 the correct oil manual points to front grill location...
  6. Absent Minded Farmer

    Classic Gehl Video With Good Variety Of Tractors....

    The nice thing about Gehl having been a short line, is the amount of different tractors used with the equipment in the videos. This is one of those videos, giving a sampling of what was on the farm in '49 & before then. There's even a budget tractor & horses in use. Though the horses aren't out...
  7. F

    400 backhoe engine swap

    Will an engine from a 2440 interchange with a 202 in a 400 backhoe? Both diesel 4 cyl. What engine choices are there for swapping?
  8. M

    Water pump

    Looking for a rebuild kit for an early model Oliver 70 with a bs350a water pump cannot find one anywhere any ideas where to look.
  9. 6

    Farmall 706 Diesel Question

    Im looking at a 706 Diesel with the 282 engine. The tractor wont start. The owner believes the ORing on the injector pump the throttle shaft goes thru is sucking air and it looses prime. He said when he can get it primed it will hold as long as you start it daily. If it sits longer than a...
  10. L

    Allis Chalmers Model G hydraulic pump lever

    On my Dads Allis Chalmers model G is a hydraulic pump bolted to the transmission. It has two levers on the top. One is for the hydraulic pressure and has linkage to a handle. The other is to shift the pump gears in and out but has no linkage. I have not seen any linkage on other Model G's with...
  11. B

    MM 605 potential

    Guys pulling molines with 605 engines, that are close to stock , what mph classes can you pull? Is 6 mph in 3rd gear in a gvi asking to much of the engine? Thanks
  12. P

    manuals

    I have a JOHN DEERE 10 A HAMMER MILL set up and operation manual. Also a JOHN DEERE NO 5 CASTER WHEEL POWER MOWER manual. Also JOHN DEERE 120 CORN SNAPPER operators manual. If you want any of these you pay shipping and they are yours. my zip is 40047. Pembroke
  13. A

    farmall HTA OR MTA HYD RESERVOIR

    NEED A HYD RESERVOIR FROM A HTA OR PERHAPS AN MTA WHICH MOUNTS BELOW THE GAS TANK AHEAD OF THE GAS TANK SUPPORT BRACKET. I KNOW THEY HAD THEM ON MTA NOT SURE ABOUT HTAS I HAVE A PICTURE OF ONE. AL MICHIGAN
  14. D

    John Deere 730 diesel surging at low idle

    Just had renaissance tractor go through the whole fuel system. Installed to the I T manual specs and timing now I m getting a surging at 700 rpm s idle. Tractor ran fine before this but I wanted to refresh the fuel system. Need help
  15. W

    1655 on hydraulic lift auger

    I bought a Hutchinson Maywrath 8 X 64 foot hydraulic lift auger with manual drive swing out hopper that I want to run with my 1655. Anybody run an auger like this with one of the Olivers with open center hydraulics. My concern is that once the auger is lifted up on the bin will there be enough...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top